Electronics Forum | Thu Mar 23 07:17:30 EDT 2023 | bukas
I have one plate and nozzle if you want dimensions. And fly camera tool.
Electronics Forum | Wed Oct 12 02:44:38 EDT 2016 | bukas
hello, I have a problem with CP45FV Neo swing mirror. The mirror it self works fine, manually controlled it moves to correct position and back. While working it also moves properly but when machine is about to check for nozzle existence at the end of
Electronics Forum | Tue Mar 07 09:35:55 EST 2017 | buckcho
hello, I have a problem with CP45FV Neo swing > mirror. The mirror it self works fine, manually > controlled it moves to correct position and back. > While working it also moves properly but when > machine is about to check for nozzle existence a
Electronics Forum | Thu Jun 25 03:08:58 EDT 2020 | jmelson
I see some Quad QSA30 machines on an auction site. They are obviously made by Samsung, and look a LOT like, maybe the Smasung CP40. Can anybody give their experience with this model? I was at an auction for a CP45FV machine, and was VERRY impresse
Electronics Forum | Wed Apr 27 04:49:16 EDT 2011 | geb
Hi Does anyone place the Rebel ES? It is the same as a Rebel except it has a raised bit near the edge of the flat area. I normally pick up the Rebel in the flat area using an 0805 style nozzle (Samsung CP45 CN065) but this raised bit makes it unrelia
Electronics Forum | Fri Sep 17 16:01:03 EDT 2021 | jamesatqkits
Hi Bukas, Do you have a CP45? I need some help: Ihave no board loaded, the machine is booted and homed. So to pick up a nozzle, I open the ANC window. Click on the nozzle I want, say 29 its a CN065 When I press pick, it asks, machine is not ho
Electronics Forum | Mon Oct 28 15:13:44 EDT 2013 | larrygroves
It will require an alignment. The tools are usually included in the toolbox, one L shaped magnetic tool, a small square glass plate and there is a tool in the nozzle changer. You can buy them seperately if you dont have them. There is a bigger qu
Electronics Forum | Thu Mar 23 04:44:46 EDT 2023 | gwideman
We are looking to obtain (probably make) the calibration tools used in the camera calibration procedures. To that end, any photos and dimensions would be highly appreciated! The set consists of one or two plates and a hat that fits on the up camer
Electronics Forum | Mon Oct 24 01:19:10 EDT 2005 | darby
Hi Mike, I use variations of both of these machines in a Tenryu FV-7100s and Samsung CP45/CP45Neos. Both have been very good machines - I would find it difficult to split them. I have personal dislikes of both tooling and support systems. I would ta
Electronics Forum | Fri May 05 09:52:52 EDT 2006 | Rob
I think perhaps you should revisit the choice and take another look at Universal Advantis, I-Pulse M2 & M4(low cost Assemblion), Samsung SM320 or CP45 Neo, Contact Systems C5, Fuji XP series, Juki KE2060, and Siemens Siplace. There is nothing wrong