Electronics Forum | Fri Apr 05 01:52:57 EDT 2024 | ddfreeze
Samsung SM321 machine fails to initialize when booting software. I have swapped PCI and communication boards, all resulting the same, I replaced the CMOS battery on communications board, tested the voltage on the backplane, and reloaded the software
Electronics Forum | Fri Apr 13 02:35:42 EDT 2018 | kimseo
PROBLEM SOLVED I bought a diagnostic PC card (ISA/PCI) for checking the PC of the machine... Firstly I tried ISA slot - nothing happend.. the diagnostic card didn't work... so I tried to put it into PCI slot but.... what happend ? The machine starte
Electronics Forum | Fri Dec 16 00:47:32 EST 2022 | enttec
Issue fixed by removing and putting the VME - PCI interface card in the X86 computer.
Electronics Forum | Wed Mar 16 06:46:59 EST 2005 | -=Verm=-
Hi lads long time no post... I have an issue with a PCB, its a PCI card that we manufacture for a customer of ours. The customer is seeing a problem with contact on a PCI card with the motherboard, the PCI card is removed from the board wiped and th
Electronics Forum | Mon Mar 28 23:52:08 EDT 2022 | glasscake
Seemed to have fixed it. When reassembling the gray PC I noticed the motion controller card can be pushed into the PCI connector rather deep. once i raised it up and only pushed it as far as the washer would have it go in it started to work again. I
Electronics Forum | Wed May 31 14:40:26 EDT 2023 | unsung
Replace the crystal in the vacuum card. I have this issue once a year.
Electronics Forum | Tue Mar 27 15:49:54 EDT 2012 | bradlanger
Try Re-seating the card that connects the ISA slot from the computer mother board to the I/O Dpram card. It may be worth checking the ISA card for bad solder joints. The computer mother board could be going bad. Check for vented electrolytic caps. Ho
Electronics Forum | Tue Mar 27 06:59:58 EDT 2012 | JB
We have an issue with our Samsung Pick & Place. It comes up with errors. No sequence-finished from handler (%1) Loading SYSTEM data to DPRAM is failed Failed to create empty document No command response from handler. (0xffff) We have tried swap
Electronics Forum | Sun May 27 04:18:22 EDT 2007 | grantp
Hi, We are currently soldering only connectors, so there is not that much to do. For the wave we currently use palettes as we solder PCI cards but don't want to wash. So the palette keeps the flux off the board. My reasons for looking at changing o
Electronics Forum | Tue Oct 10 23:22:11 EDT 2023 | unsung
I've fix alot of these samsung machines. Do you have a picture of the error or screen that says not loading program. My email is marlonquiroz84@gmail.com ( also the fuses should be located on the back of VME card green color smt chip. ( I highly doub
