Electronics Forum | Sat Jan 23 05:21:09 EST 2016 | spectrumsmt
Hi Rick, we sell a very good after market recalibration jig which is available to calibrate most makes including Samsung. We also sell nozzles and feeders! Please get in touch or have a look at the website spectrumsmt.com All the best Ian
Electronics Forum | Tue Jun 18 23:29:02 EDT 2019 | SMTA-David
Hi, I have an older Samsung pick and place (CP-40LV model). During last few runs I have experienced several feeders with the clear plastic tape cover not peeling back to expose the next part. I manually pull back the tape and it runs for a while and
Electronics Forum | Mon Aug 05 20:40:50 EDT 2019 | dunks
deleted
Electronics Forum | Tue Nov 17 15:41:11 EST 2020 | bobpan
use password Scpssa
Electronics Forum | Tue Nov 17 17:23:20 EST 2020 | empac
will try. Thank You. David
Electronics Forum | Wed Nov 22 10:32:46 EST 2017 | itactilum
I need the soft for samsung cp40 lv + i can't find it. reinstall the s.o and I would need the soft. on the other hand it gives me an error that begins to give continuous beeps without stopping and I get the following error message "no sequence fini
Electronics Forum | Wed May 25 19:47:01 EDT 2005 | russ
It wouldn't be that many placements (billions) since we are a low volume high mix shop but we have placed 100s of thousands with the N08 for sure. We use the N045 by far the most since we seem to be an 0603 and smaller type shop (probably into the m
Electronics Forum | Wed May 25 13:02:57 EDT 2005 | jsloot
I have two Samsung machines running about 500 hours a month each. Placement rate is on the average 12,000 CPH between the two. The life expectancy of the nozzles used on 1206 packages seems rather short to me. It was about 2 months ago I replaced the
Electronics Forum | Wed May 25 17:33:52 EDT 2005 | russ
What's going wrong with the nozzles that you have to replace? Are you running CP40 / 45 models? We have used our N08 nozzles for 5+yrs now without replacing. Russ
Electronics Forum | Wed May 25 18:27:06 EDT 2005 | russ
So what is happening to these nozzles? Are they sliding off of the compliance assy?, getting dinged? Have you contacted dynatech SMT about this yet?
