Electronics Forum | Tue Oct 11 15:21:12 EDT 2005 | Hoss
Sean, If the machines use more than the spec'd 8CFM, are not leaking and work fine otherwise, I wouldn't disqualify them on that basis alone. You may be exceeding the duty cycle rating of your compressor and not necessarily the volume. If Samsung
Electronics Forum | Fri Mar 06 02:25:08 EST 2020 | bukas
it is not that big deal. you can use almost any generic grease. I use SKF bearing grease on CP45FV's. Just make sure you remove old grease, I use IPA and compressed air to do this. And don't put too much of it or too little. After greasing everything
Electronics Forum | Tue Oct 11 13:25:41 EDT 2005 | Sean Jiam
Hi, We just purchased the above two machines and they're still in the trial period. We have problems with air requirements of the above two machines. For example, Samsung CP45 is listed at 8 CFM only, but it will kick off the compressor (rated at
Electronics Forum | Wed Jan 03 15:24:49 EST 2018 | proceng1
I'm not sure it would explain your feed issue, but the main thing that we have found to cause problems is the two nylon gears that pull the tape. The teeth get bent, and they don't mesh together as well, causing the tape to not pull correctly. Or t
Electronics Forum | Wed Jan 10 09:36:06 EST 2018 | buckcho
Interesting. If all 52 of them fail, you need to change one special part that is controlling the air cylinders, I forgot the name, it was long time ago I used the machine. I there a possibility to test them on other machine, maybe some other company?
Electronics Forum | Tue Oct 11 18:35:59 EDT 2005 | stepheniii
How big a tank do you have at the compressor? Basically the bigger the better. You will still have the same duty cycle ratio but the compressor won't be cycling as fast. Hopefully someone here knows what a good size would be. And when you say "kic
Electronics Forum | Wed Oct 12 07:47:42 EDT 2005 | Comp tech.
Sean, I just installed a whole new comp room in our facility. 1, By kick off do you mean the comp goes into an idle mode,or shut down completely? If it just goes into an idle mode, this may be caused by your supply manifold being to small in diameter
Electronics Forum | Fri Jan 05 11:10:05 EST 2018 | andrewnoland17
hello, my colleague ProcEng1 is right. The main > problems are the gears, which easily are stuck > with foil, the shutter, which has to be > lubricated and not bend. Air cylinders on the > machine have to be changed if you have misfeeds > still.
Electronics Forum | Thu Jan 04 02:40:55 EST 2018 | buckcho
hello, my colleague ProcEng1 is right. The main problems are the gears, which easily are stuck with foil, the shutter, which has to be lubricated and not bend. Air cylinders on the machine have to be changed if you have misfeeds still. They look pret
Electronics Forum | Thu Oct 04 00:05:25 EDT 2018 | gaintstar
Flason SMT chip mounter Reflow Ovens: http://www.flason-smt.com/product/PCB-assembly-line-equipment-SMT-spare-parts-Dek-Motor-188962.html http://www.flason-smt.com/product/PCB-Conveyor-for-LED-Production-Line-SMT-Assembly-Line.html http://www.flason-
| 1 |
