Electronics Forum | Mon Jan 03 05:34:16 EST 2011 | jmw
Check in you system configuration that you dont have the opiton to use a matrix tray handler turned on. This is what i have seen cause this problem.
Electronics Forum | Tue Apr 11 03:01:52 EDT 2017 | tsvetan
check if the top plate which is used for tray change is on it's place, also in manual mode you can see on Sig.IO page all sensors status and you can figure out which sensor is activated
Electronics Forum | Fri Dec 31 12:26:29 EST 2010 | kvael
Has any one had this problem? Dynatech says it is the I/O Dpram board, sold me one that dosen't work. Bought a second Dpram from SMTBOX, still have the same original problem. During Dpram initialization error comes up "no command response from handl
Electronics Forum | Mon Feb 18 09:49:43 EST 2019 | bobpan
This is going from my memory from a long time ago...but in the scp.ini file....there could be digital light control and/or a matrix tray handler setting. I would turn them off if they are on. I believe this has something to do with a system setting.
Electronics Forum | Sun Nov 26 09:52:50 EST 2017 | robertorocco
Hi Muzzy. I have a problem with the software. It si possibile copy the software on the HD or is necessery install it? Do you have the original floppy for the installation Samsung program (ODBC, vme,ecc)?
Electronics Forum | Mon Jan 18 12:03:37 EST 2016 | rfm2nd
would anyone possibly have the calibration jigs to be used in calibrating the cp-45 and/or the cp-60 machines from Samsung?
Electronics Forum | Mon Jan 18 12:04:24 EST 2016 | rfm2nd
would anyone possibly have the calibration jigs to be used in calibrating the cp-45 and/or the cp-60 machines from Samsung?
Electronics Forum | Sat Jan 23 05:21:09 EST 2016 | spectrumsmt
Hi Rick, we sell a very good after market recalibration jig which is available to calibrate most makes including Samsung. We also sell nozzles and feeders! Please get in touch or have a look at the website spectrumsmt.com All the best Ian
Electronics Forum | Sun Dec 28 10:19:10 EST 2014 | erikgfrey
Did you ever find a solution to this problem?
Electronics Forum | Fri Feb 13 05:37:31 EST 2015 | luca2006
Hi could anyone helps me with advanced password for cp40cv
winsouce.jpg)
