Electronics Forum | Sun Mar 24 16:53:44 EST 2002 | mikestringer
We place a similar square pin style of connector on one of our products. The connector is a 22mm high HW series from Samtek. We have a Yamaha YVL88 MK1 and YV88XS set up to handle them (Yes they are rebadged as Philips machines in some markets). No
Electronics Forum | Wed Oct 30 15:50:22 EDT 2013 | joeherz
Vince, We see the same disks on some parts incoming. SMT PEM nuts in tape and reel are very common. We get the parts from PENN Engineering. One of them is SMTSO-M3-4ET. PENN Engineering may be able to steer you in the right direction on who their
Electronics Forum | Fri Oct 13 19:01:46 EDT 2023 | crystalw4280
I have an old Juki 2060 The electors were replaced on some heads that were disabled. Now we are showing some of the same errors with those heads. Does anyone have any suggestions for possible cause that would make this happen again. Another warning
Electronics Forum | Tue Oct 24 19:09:12 EDT 2023 | sarason
Possibly blocked air lines did you check air pressure? Also drivers on the relevant boards. or simply damage in the flexible wiring harness( a nightmare) sarason
Electronics Forum | Fri Mar 11 10:51:29 EST 2005 | mfoster
Samsung Back-up pins available from Dynatech for $30 each. http://www.DynatechSMT.com
Electronics Forum | Fri Mar 11 10:00:22 EST 2005 | ???
Anybody out there know of a good (2nd) source to purchase single magnetic board supports used on quad/samsung machines. These are spring loaded and contact the underside of the board in the pick n place machine
Electronics Forum | Thu Dec 28 22:00:45 EST 2006 | Sue Kim
Hi all, I am doing some research on SMT machines. I would like as many people as possible to rate the following machines 1-6. The number 1 would be the best, number 6, the least desirable of the 6. I realize that there are dozens of factors to con
Electronics Forum | Wed Jan 30 08:27:37 EST 2019 | mst3000
Hi there. We are facing an issue with the placing head of our SMT machine SIEMENS SIPLACE CF 2004 model where the vacuum reading is low (820 instead of 900). This is resulting in that the components are either falling off when the head moves onto the
Electronics Forum | Mon Dec 20 19:09:54 EST 1999 | Chris
If your flex circuit is only populated on one side, you can have the PCB vendor palletize the flex for you. What you do is have the flex circuit laminated to 062" FR4 using a thermoset adhesive like Dupont WA. Standard flex circuit adhesive. Howev
Electronics Forum | Mon May 06 11:45:32 EDT 2019 | slthomas
There are quite a few papers out there on the subject. Just enter "SMT void reduction" into google or other search engine and take your pick. That said, slow ramp rates and paste volume reduction are a good place to start. Although I haven't tried i
Main Products: 1. Original new and Original Used SMT/AI Spare Parts. 2. SMT Equipments And Related Machine( SMT Calibration, SMT Feeder Carts,Conveyer etc.) 3. Maintenace and Repair Service Pre-Sales Service Provide details ab
Manufacturer's Representative / Manufacturer / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
Building A, Jiepeng Square, Fuyong
Shenzhen, 30 China
Phone: 0755-33578694