Electronics Forum | Wed Oct 12 02:44:38 EDT 2016 | bukas
hello, I have a problem with CP45FV Neo swing mirror. The mirror it self works fine, manually controlled it moves to correct position and back. While working it also moves properly but when machine is about to check for nozzle existence at the end of
Electronics Forum | Tue Mar 07 09:35:55 EST 2017 | buckcho
hello, I have a problem with CP45FV Neo swing > mirror. The mirror it self works fine, manually > controlled it moves to correct position and back. > While working it also moves properly but when > machine is about to check for nozzle existence a
Electronics Forum | Tue Mar 07 17:31:25 EST 2017 | kahrpr
The mirror should stay open. go to sys setup go to head go t nozzle check settings. that is were the nozzle check is at
Electronics Forum | Thu Mar 23 07:17:30 EDT 2023 | bukas
I have one plate and nozzle if you want dimensions. And fly camera tool.
Electronics Forum | Thu Jun 25 03:08:58 EDT 2020 | jmelson
I see some Quad QSA30 machines on an auction site. They are obviously made by Samsung, and look a LOT like, maybe the Smasung CP40. Can anybody give their experience with this model? I was at an auction for a CP45FV machine, and was VERRY impresse
Electronics Forum | Thu Mar 23 04:44:46 EDT 2023 | gwideman
We are looking to obtain (probably make) the calibration tools used in the camera calibration procedures. To that end, any photos and dimensions would be highly appreciated! The set consists of one or two plates and a hat that fits on the up camer
Electronics Forum | Fri Sep 17 16:01:03 EDT 2021 | jamesatqkits
Hi Bukas, Do you have a CP45? I need some help: Ihave no board loaded, the machine is booted and homed. So to pick up a nozzle, I open the ANC window. Click on the nozzle I want, say 29 its a CN065 When I press pick, it asks, machine is not ho
Electronics Forum | Tue Jun 23 21:48:06 EDT 2020 | jmelson
I don't know much about Essemtec, I have been looking at Neoden a little. At least the Neoden is not in any way in the same class as machines like Assembleon or Samsung. I did download the manual for a Samsung CP45FV NEO, and the programming side o
Electronics Forum | Thu Jun 18 23:24:12 EDT 2020 | jmelson
About 12 years ago, this forum was hugely helpful in guiding me to get a Philips CSM84, with no vision. (That might have been a mistake.) Now, I'm moving to smaller parts, especially TSSOP and QFP with 0.5 mm pitch, and the CSM just isn't accurate
Electronics Forum | Sat Jun 27 17:49:24 EDT 2020 | jmelson
I can't find much info on the older Essemtec machines. First, I'd want to see the "spec sheet", then I'd want to find out what the programming environment is like. (I was really impressed with the Samsung machines in that regard.) I have not seen
.gif)
winsouce.jpg)