Electronics Forum | Tue Nov 21 11:07:24 EST 2006 | ratsalad
If anyone is interested, I've written a program to read the PanaPRO .pcb file and generate a Sanyo TCM-V850/UIC 4785 program. It sure beats entering the program manually.
Electronics Forum | Mon Jan 19 09:07:45 EST 2015 | cotinc01
We can offer several nozzles to assist with the placement of 0402/0201 components in the four-spindle head. We offer the 06MPF along with custom ceramic tipped nozzles. Most of our standard nozzles for this head type are less than $125.00 each. Chec
Electronics Forum | Thu Jul 07 07:27:10 EDT 2005 | buchi79
Are you buying nozzles from UIC or other vendor? By the way, what is the component you rejecting? Is it happening to random component or specific one?
Electronics Forum | Wed Jul 27 12:50:59 EDT 2005 | mnguyen
You may want to look at which spindle that is dropping the nozzle and check the O-ring on the spindle head. It's probably bad, cracked, or broken. Replace it and that will fix it
Electronics Forum | Fri Jan 16 16:34:01 EST 2015 | rgduval
It's a four-spindle head. I've already learned the joys of the size of the nozzles...on a job that had an 0603 cap a bit too close to an SOIC. The first panel ran, and the cap placed after the IC...and I had parts everywhere. Got it figured out an
Electronics Forum | Tue Nov 21 13:20:03 EST 2006 | Kerwin Hooshey
Mr./Ms./Mrs. Cuculi, Are you offering this software for free?
Electronics Forum | Tue Jul 05 16:29:27 EDT 2005 | stepheniii
The air kiss is to replace the vacuum with air so the part will drop off the nozzle. Every machine I've seen with Air kiss, uses it when discarding a part as well as when placing a part. The air kiss should not be strong enough to blow the nozzle off
Electronics Forum | Mon Jul 04 11:32:44 EDT 2005 | geb
One of my Universal GSM (1995/ 1996 model) pick and place machines has recently started to drop the nozzle on the reject belt when dropping off a rejected component. I have tried replacing the nozzel holders on the ends of the spindles but with no im
Electronics Forum | Sun Feb 13 16:28:00 EST 2011 | tpappano
Does nozzle #1 lower at all when it should pick up a part or is it just staying in the fully up position? If it does come down, but not quite far enough to contact the part, there are adjusting nuts on top of the head that set the lower limit for no
Electronics Forum | Sat Feb 12 13:19:27 EST 2011 | tpappano
A simple trick I read either here or on another P&P forum is to use "Silly Putty". Place a small thin spot of Silly Putty on the top of the front conveyor rail, and put the machine in "manual" mode. Steer head #1 over the putty and lower it, leavin
