Electronics Forum | Fri May 28 01:47:05 EDT 2010 | jeffr
I have the part you need. The Yamaha Part number is K39-M7173-000. The same part is used on Philips machines using a different part number. This assembly is expensive because the motor is attached to a Harmonic Gearbox and encoder. I have a new unit
Electronics Forum | Mon May 04 14:24:12 EDT 2009 | jimmyboz
Ok, So, If all the servo amps on H1 remained on H1 and the amp you changed is on H2, I have to guess the shifting on H1 is unrelated to the servo prob. Is the shifting unsolderable? if it just looks bad but will reflow, it may have been occurring f
Electronics Forum | Fri May 01 22:22:20 EDT 2009 | rodrigo
We didn't leave them swapted. They were placed in the original position until we got the replacement. What has me puzzled is that it worked for one panel correctly. I want to answer the other posts here too ... SA-6 is for Z2 The amp showing 7 is f
Electronics Forum | Fri May 01 00:27:12 EDT 2009 | rodrigo
Hi all, We had a servo amp replaced (SA-6) and the machine worked with no problem for the first panel (this panel of 10 only needs a TQFP100 from the MTU). Then I got the "Servo NG" error again. One of the servo paks showed a "7" on the LED. The err
Electronics Forum | Fri Jan 10 15:33:57 EST 2014 | hans88
Hello Rob, Thanks for your fast reply. I will check the parts you mentioned. You were right about the mot card we swaped it with a new one but that made no difference. Today we tried to find were the problem could be we: - removed the j1, j2 and
Electronics Forum | Fri Sep 11 17:02:10 EDT 2015 | adeanda74
Simon, Normally that error is caused by a bad motor but also there is a possibility that a driver board or even the servo board are defective and last but not least check all your cables and connections. finally let me mention that you can also recei
Electronics Forum | Mon May 16 00:33:18 EDT 2016 | wesleyintelli
Our CP45 swing mirror motor (Panasonic AC Servo Motor: MSMA012A3A) recently jammed and required replacement. I replaced the motor with a new one however it won't home. A link to a video of the motor attempting to home can be seen below. I am wonderin
Electronics Forum | Fri Jan 10 03:33:42 EST 2014 | hans88
hello people, we have a my12 wich has a problem it gives the following error during hardware initialization: F-MOT-MSETDYN Y/1236 :Motor amplifier channel a error. after this error it says hardware initialization failed. this prevents us of using
Electronics Forum | Tue Jul 18 15:16:40 EDT 2017 | robertbronx
Showing on screen this message: MIPR2: Fatal Error. Reloading Motor Controller M First time I connect and only have this message on screen. The manual only says; 1) SOFTWARE PROBLEM IN THE MOT-M SERVO PROGRAM. 2) THE MOT-M OR MI board is broken. Plea
Electronics Forum | Wed Oct 26 18:25:13 EDT 2005 | darby
The encoder on the Y axis motor is almost certainly kaput. Debris from the wear of the motor brushes or whatever else can find its way onto the encoder and give an ever increasing false pulse. The axis will start OK but progressively go out of whack