Electronics Forum | Tue Oct 14 14:08:22 EDT 2014 | dilogic
No, each card in LP servo rack drives only one motor. But there is an servo cotnroller board (actually 3 of them) in the VME rack (where all computers are). Third one from the left(slot13) controls head2 theta and z axis. That might be a cause of you
Electronics Forum | Mon Aug 31 16:48:16 EDT 2020 | aurash
I wish it was so simple :-) In their wisdom the machine designers choice was to have servo drivers with two channels (one channel less powerful and one channel more powerful) - so each card is driving a X motor and a Y motor.(the X axis is made of 2
Electronics Forum | Tue May 08 13:02:39 EDT 2007 | jmelson
I need a service manual for a Philips CSM84 type PA1306/20. I have the PA1306/40 manual, if that is any use to anyone. The 1306/20 was the last model with analog servo amps and DC brush motors, the 1306/40 was the first with AC brushless motors and d
Electronics Forum | Fri Jun 08 18:30:53 EDT 2007 | jmelson
I have the entire computer box assembly from a 1306/40 series machine. This was one of the first with the AC servo motors and digital drives. It was taken from a working CSM66 at the same time as I bought a CSM84. It was included to be used as spa
Electronics Forum | Thu Feb 13 09:52:03 EST 2014 | rgduval
Start by getting into the maintenance menu, and manually installing the Servo program for all MOTs. If they install fine, you can check the Z-motor while you're in the maintenance menus. Make sure that the z-locks are unlocked before checking the
Electronics Forum | Thu Nov 24 04:21:02 EST 2005 | Twistie Ng
NEED EXPERTISE HELP / SOLUTION for Sanyo TCM-V822 High Speed Mounter. Errors Message Code : REEL TIMING 01 18 & REEL SERVO 01 01 ============================================================ This unit has yet to run since our purchase a month ago.
Electronics Forum | Fri Aug 18 14:31:53 EDT 2006 | vikkaraja
I have humming noise comming from my Z axis motor for a while now. It faults out every so often, but not enough to stop production. I even can hear it while machine is in normal production mode. I have replaced the z servo amp. It did not help any. O
Electronics Forum | Thu Apr 28 03:58:52 EDT 2022 | erici
We are having problems with our Siemens Siplace S27 machine. The machine is giving the error - Y-axis Faulty initialization of Motor. We replaced the Y motor card and swapped also the servo control cards on the two gantries. Still will not initiali
Electronics Forum | Fri Sep 08 11:06:11 EDT 2006 | fabio
the video and the servo motors don't start... i need a wiring diagram to make the measures... please help!!
Electronics Forum | Wed Nov 30 14:27:27 EST 2011 | bobpan
The machine has linear servo motors. It has to be VERY level. You may want to check that this is the case. If this doesnt work.....make sure the encoder scales are clean. Good Luck
.png)
