Electronics Forum | Tue Feb 27 10:34:37 EST 2024 | clpassoni
Servo motor. Maybe it's a weak encoder? This can happen? Is there any adjustment that can be made?
Electronics Forum | Mon Oct 10 15:24:15 EDT 2005 | zl3vlf
Hello to all! Our Fuji FIP-3 placement machine has come up with a servo alarm (X2-axis) whenever we try to run the machine. The manuals don't go into a lot of detail as to the cause of this problem, but there is plenty of information on what the X2
Electronics Forum | Tue Jun 23 08:08:38 EDT 2009 | ptxems
We have a couple of Zeva/Juki PM570L's. One machine has developed a fault with the z axis motor. It is continually 'buzzing', we have checked and there is 24VAC on it. Although even on the other machine there is AC voltage on the motor. We have sw
Electronics Forum | Thu Feb 13 00:43:06 EST 2014 | brendansales
Centering motor about to fail or has failed. > Centering motor about to fail or has failed. Hey Rdubya, Thanks for your help! Apparently that was not the problem. The Midas head had to be all the way down below the lower locking solenoid. After
Electronics Forum | Fri Jul 09 17:52:43 EDT 2021 | glasscake
Hello, I have a Topaz-X that is losing its R origin as it runs. The issue can be seen in the following test: Set the machine to ignore vacuum/ignore alignment and have no feeders in the machine also set the nozzles all to fixed. I run a servo orig
Electronics Forum | Wed Nov 02 16:35:20 EDT 2016 | csm
Dear FUJI Specialist, I need your HELP, we have an CP8-42-E and machine was working properly and from one day to another when we Turn ON the machine make all the startup and check all the list, when all is ready, you have to Puch Ready and automaticl
Electronics Forum | Wed Jun 27 11:58:42 EDT 2012 | cyber_wolf
Your tool tips are being damaged because the small x-motor is not engaging when the head is picking parts. When this happens the head overshoots and you bang the tips on the mag springs. Directly after a tip gets damaged go into the service program a
Electronics Forum | Thu Sep 16 21:22:39 EDT 2004 | Darby
Cesar, I am not familiar with these machines but I have found that servo controller problems do not usually cause mis-placement. They tend to just stop the machine with *axis system erors. As I understand it, after you have done a return to origin,
Electronics Forum | Thu Feb 04 09:18:18 EST 2010 | mika
Problem! Then replace the motor! Why not replace be belt anyhow? How long was it since the last time you replaced any belt? Another thing you could also do; In the LP (Low Power) chassis lower front left, find the correct motor servo card and "Null
Electronics Forum | Mon Nov 07 20:52:39 EST 2011 | jeffr
Tom, V3.78 is truely a bad version and does not include GLOAD. Files taken from the machine with V3.93 can stumble, but can be read... so I would recommend burning V3.93 EEPROMs. Only do this if both machines have Vision and DC Servo Motors present.
.gif)
