Electronics Forum | Thu Feb 14 21:52:56 EST 2008 | keithej2
Thanks for the reply. The IP3 we're working on is a 4400. We installed a new motor/encoder today but it didn't help. So far we've swapped the CPU, vision card, both LSOs and the servo cards. We've been poking around the relays and wiring tonight but
Electronics Forum | Sun Jul 05 23:30:01 EDT 2009 | jeffr
A feedback error means that a particular axis did not respond by moving in a normal manner. Check the following:- 1/.. Mechanical binding. (Servo Off, then check axis moves without binding). 2/.. Check encoder plugs of that axis. Note that Philips/Ya
Electronics Forum | Mon Mar 26 17:09:48 EDT 2012 | test_tech
I have an Eclipse 1, that is no longer in production use for pick and place, but I would like to use the the gantry system and install a custom head to perform other tasks. I am looking for some guidance or information on how the existing servo con
Electronics Forum | Thu Sep 24 00:52:41 EDT 2015 | ermani9
Hi.. Move the XY arm to the center of the machine. Turn on the servo then immediately hold “LOWER” then press “ORIGIN”. You should see the message now on the screen “DRIFT CHECK”. The arm will start to drift without an emergency condition occurr
Electronics Forum | Mon Jun 12 17:54:17 EDT 2017 | simons
The machine does not move to the home position. Once we hit the "Home" button all three heads will move up to the "Home" position but then 5 to 10 seconds later the following error pops up "Error 1531 - Z Axis motor alarm" before any "xy" movement i
Electronics Forum | Thu Jun 29 17:55:05 EDT 2017 | anilbasra
I have a SCS-4398 coating machine software ver:2.04E. This morning when the operator starter the machine instead of reaching out to its Home position the spray head started to hit the opposite end several times in small cyclic distance. Screen is di
Electronics Forum | Fri Jan 05 10:58:43 EST 2018 | ilavu
John, I just found out more detail. If my board stop position in x is bigger than 109mm, I get error from park position to board stop.This problem started after power loss. The error comes up system power down and after pressing system button "RISIN
Electronics Forum | Sat Aug 08 23:38:06 EDT 2020 | jmelson
Well, the machine is here, it has some probems that I need to diagnose, and now I ***REALLY*** need the manuals (both maintenance and operations). Two problems. One is that it will only come "ready" (servos powered on) ONE TIME per day! I'm totall
Electronics Forum | Tue Sep 14 13:01:11 EDT 2021 | jamesatqkits
Hi Bukas, Every head, yes they move down, I should have mentioned the sensor is on the right , not the left. It detects the mirror swinging down. There is another sensor on the servo motor, its mirror home, it works I see it changing when I break the
Electronics Forum | Tue Jun 23 13:50:05 EDT 2020 | dltechltd
505.05 SP2 Hotfix3 After this, we were able to work with the machine until 1 week and the machine broke again. A small zener diode exploded on a Servo card, and we replaced it. Next reboot, the MC system halted, because an SRBS error. We have aske
