Electronics Forum | Tue Nov 19 12:34:33 EST 2013 | jimmyboz
I am not trying to be critical but, you didn't even say Fuji CP-6 problem. There are CP-6, CP-642, and CP-643 machines, are asking 2 model as 642? Anyway, slow the cam speed down in the proper to 40 or 50%. If the problem goes away check the mainte
Electronics Forum | Wed Dec 18 22:41:36 EST 2013 | dekhead
You don't say what software version is running on machine; generally caused by corrupted file; delete E: config local.lpf file and then reboot machine (new file will be created). If not this, recommend reload of machine software (should not require s
Electronics Forum | Sun Jan 12 03:20:37 EST 2014 | alexeis
Hi, Can you say why you need to translate? If you need to display information technicians, we have a solution that supports a wide variety of CAD files including those specified. Feel free to read our product called RStation and the ARC solution bas
Electronics Forum | Tue Feb 11 12:02:52 EST 2014 | javierec
Process: Batch Cleaner, @16% concentration. Concentration is checked daily. Cleaning after Wave Process. See attached pictures and comment and what you think causes the solder joint to turn grey. i have read post that say the grey dull looking sol
Electronics Forum | Tue Feb 18 11:02:05 EST 2014 | cunningham
Thanks for the reply. Yes we currently have an Ionagraph setup at the bottom of the wash where we take the first board out for that day and check it for contamination. Im just wanting to get an idea if any jets are blocked and that the temperature
Electronics Forum | Thu Feb 27 13:59:52 EST 2014 | rway
I agree with Comatose; although, 30 seconds I feel is stretching it bit. I would say anywhere from 40-60 sec. 5 seconds for removal 15 seconds to install (tack) 10 seconds to solder 10 seconds for inspection There's no need to dress the pads. Use t
Electronics Forum | Wed Mar 19 17:18:24 EDT 2014 | aybars
I would suggest to check your servo amps. on both gantries and both axis.Does it rattle both heads or just one? Since you did not specify this in your question,I will say check all 4 servos in the back side of your machine.Hope this will help and goo
Electronics Forum | Wed Apr 09 03:32:49 EDT 2014 | sarason
Place a Digital CRO on that 24V rail. Watch the output. trigger on voltage drop lets say 18V picking a figure out of the air. You may well have another rail in your supply or nearby pulling your 240V //110V rail. Most likely a shot Electro either on
Electronics Forum | Thu May 08 18:21:13 EDT 2014 | jorge_quijano
Hola, We are about to start building a new PCBA using a LGA, we have not used such components in the past, is there any recomendations you can provide me? I've found some articles saying that stencil thickness is the key, what is your experince usin
Electronics Forum | Mon Jun 09 09:52:10 EDT 2014 | swag
Yes, jsd.jwww it can be seen right after reflow. I read back thru the spec sheet and under "soldering conditions" is says "temp. at cap surface" so thanks, SteveO I think you hit the nail on the head and we'll have to revisit the profile and target