Electronics Forum | Thu Aug 31 14:15:34 EDT 2023 | compit
Hello What feeder do you use for the long connector (65-80mm) - tape feeder, tray? What nozzles? We want to mount a SODIMM200 socket. I don't know whether to look on the tape or on the trays... The MG1 spec says it will mount connectors up to 100mm (
Electronics Forum | Tue Oct 03 18:13:46 EDT 2023 | glasscake
Its ether going to be in the settings before launching the software at the login screen or the settings after launching the softer on the top right. You should see some tab relating to defects. There should be a setting that says something along the
Electronics Forum | Tue Oct 10 23:22:11 EDT 2023 | unsung
I've fix alot of these samsung machines. Do you have a picture of the error or screen that says not loading program. My email is marlonquiroz84@gmail.com ( also the fuses should be located on the back of VME card green color smt chip. ( I highly doub
Electronics Forum | Fri Oct 27 14:54:29 EDT 2023 | proceng1
I won't answer your design question, as I don't do PCB design. I will say that if your product is to ROHS, make sure that the connector you choose can handle the REFLOW temperatures required. As a CM, we have had some products that were intended fo
Electronics Forum | Fri Jan 05 16:16:51 EST 2024 | mistrthou
Based on the my15 we used to have and our current My100's I'd say it lost the position of the tool bank. Is it Hydra or Midas tooling? Uninstalling and reinstalling the hydra tool bank is fairly easy. If it's Midas tools, does it fetch other tools
Electronics Forum | Fri Jan 05 20:26:48 EST 2024 | kristi
I am in search of a boot disk for an Electrovert Econopak Plus. First our CMOS battery died, we wired a 3V battery to it and that works fine now. However now it's saying the diskette is unable to boot. The disk drive passes test, and I have installed
Electronics Forum | Fri Feb 02 16:26:27 EST 2024 | tey422
It's very common practice to have multiple images on one stencil, it saves money & store space. The biggest drawback I would say is the stencil would wear out faster than as single, due to more frequent usage. One more thing, before you place the ord
Electronics Forum | Tue Mar 19 13:25:53 EDT 2024 | jdengler
This was 10 years ago so the results are not valid for todays equipment. I will say that we were surprised at the range of results. We also did not limit it to 3 vendors but did 5. Our priorities were likely different than yours also. In order of
Electronics Forum | Thu Mar 28 16:51:00 EDT 2024 | tey422
Since you only saying it's the hydra error, then only run the hydra calibrations. Sometime the calibration can end up causing more issue if not run it correctly. I would do the hydra camera Z level (1st). If it fixes the issue then you no need to do
Electronics Forum | Sun Apr 07 20:35:00 EDT 2024 | jayx
I'd say it's much easier to do the external batter mod than replace the whole Dallas module. I've done it, works fine. There is a chip in the socket next to the module, best to remove it and put back when you finish with the mod.
