Electronics Forum | Mon Feb 10 14:29:01 EST 2014 | dilogic
Sorry, I did not check the forum for a few days. Slot 12 controller is in charge for PWC and Beam1 Head1 (front) theta and Z axes. Which sw. version is installed on your machine?
Electronics Forum | Wed Feb 05 11:39:23 EST 2014 | escalador
Hi, I have an old GSM1 p&p machine unused for some time and I would like to know if someone can give me the correct jumper settings for the 3 Radisys UIMC axis control cards that go on slots 10,11 and 12.Someone modified card positions and I dont kno
Electronics Forum | Tue Aug 07 08:43:59 EDT 2018 | joycehughes
Does anyone have one, or know where we can find one?
Electronics Forum | Tue May 26 23:42:20 EDT 2020 | smiran082
Hello, I am having trouble the QSV-1 PNP machine. On boot it had trouble connecting to the RT computer as it was hung on a message saying something along the lines of, "Establishing connection to RT computer". After several restarts we still could
Electronics Forum | Mon Aug 19 18:03:38 EDT 2013 | jorge_quijano
Hola I'm looking for an obsolete card for one of our AEP 12T presses (ASG), it is the acroloop 8010 controller, if you know where can I find it, please let me know. Original vendor does not have them since they are obsolete. Gracias!
Electronics Forum | Tue Nov 13 11:41:23 EST 2012 | dontfeedphils
I can't remember what motor control cards in the machine are interchangeable, but if the controller card for the theta axis is a common control card then you can swap out the one currently controlling the theta axis with a different axis and see if t
Electronics Forum | Tue Jan 13 08:08:37 EST 2009 | leemeyer
I am assuming that the card that was changed was the motor driver card. Did they change the card with a known good board or just swap the X and Y cards. If they swapped cards it appears that the card that is now in the X motor slot is bad. Open the a
Electronics Forum | Wed Mar 23 20:13:19 EDT 2016 | ttheis
UPDATE: For anyone experiencing similar issues it looks like it is bad axis control card(s.) It would make sense since that is what the message said... A red "fail" led was overlooked on one of the cards apparently. I had this same issue with anothe
Electronics Forum | Tue Jul 15 17:30:38 EDT 2003 | ServGuy
00c is a hardware interuption Addr F92228A0 is out of the card rack, meaning probably the CPU or memory PCB is out of control. Swap the 1st and or last card in the card rack with another machine or from spares.
Electronics Forum | Wed Sep 25 13:39:11 EDT 2013 | bobpan
I have rarely seen a bad SRX controller card but it sounds like you may have a faulty card. Since i know you have 2 machines...i would swap them....make sure you take a picture of it or write down where all the cables plug in. The SRX board is locate
.gif)
