Electronics Forum | Mon Feb 07 13:37:19 EST 2011 | dekhead
You don't say what generation of 248 we're working with... there are a few. Get in touch; I should be able to assist. http://www.dekhead.com
Electronics Forum | Thu Apr 06 14:27:04 EDT 2023 | jdengler
Hi everyone, I am looking for a schematic in PDF for an OmniFlo 7 manufactured in 2003. Our hard copy has gone missing. Specifically I am looking at which SSR controls zone 2 bottom heater. Thanks, Jerry
Electronics Forum | Thu Apr 06 16:08:17 EDT 2023 | jdengler
Thanks for the effort. I have the maintenance and operations manuals in PDF so they are not missing. It looks like the only place it will show which SSR controls which heater will be in the schematic.
Electronics Forum | Thu Apr 06 15:58:32 EDT 2023 | proceng1
Engineering Data sheet is the best I can do.
Electronics Forum | travishemen |
Mon Apr 10 14:32:07 EDT 2023
Electronics Forum | travishemen |
Mon Apr 10 14:33:58 EDT 2023
Electronics Forum | Mon Apr 10 15:04:52 EDT 2023 | jdengler
Travis, Thank you very much. Jerry
Electronics Forum | Sat Sep 12 02:16:41 EDT 2020 | jmelson
Arrgh, that's an SFA-410ED camera, original subject was wrong. Hello, the down camera on my Quad QSA-30 has gone haywire. It still puts out video, but does not sync to the vision system, the picture rolls horizontally. I have verified the vision int
Electronics Forum | Thu Dec 03 14:40:27 EST 2015 | proceng1
When we had a line that ended at an older reflow oven without SMEMA controls, I ran a momentary switch to the two pins in the connector. I push the button and the conveyor pushed the board onto the edge-hold of the oven. As a joke I labelled it "LA
Electronics Forum | Thu Dec 03 14:45:16 EST 2015 | ttheis
Thanks. Our older oven does have a basic PC interface but no SMEMA. Maybe I can write a short program for the oven's PC to pace the boards into the oven. I could interact with the conveyor's SMEMA interface via low-cost Arduino or something similar.
winsouce.jpg)
