Electronics Forum | Tue Jun 22 13:35:40 EDT 1999 | Jason Gregory
I am need of info regarding the tape cutter blades for a Sanyo/Universal 4760 HSP chipshooter. Ours are gone and beyond repair. I have found that the blades are the same as on the 4765 HSP. Part nos. are UPPER-6300056280 LOWER-6300056273 Please he
Electronics Forum | Tue Jun 22 13:37:56 EDT 1999 | Jason Gregory
| I am need of info regarding the tape cutter blades for a Sanyo/Universal 4760 HSP chipshooter. Ours are gone and beyond repair. I have found that the blades are the same as on the 4765 HSP. Part nos. are | | UPPER-6300056280 | LOWER-6300056273 |
Electronics Forum | Mon Feb 13 17:27:19 EST 2006 | PWH
I have not used one of these jigs. We just make sure and reset feeder B offsets before every build. We've also got good at guessing where a missed pick-up is just by looking at the position of the tape pocket in relation to adjacent feeders and cha
Electronics Forum | Wed Sep 21 10:40:18 EDT 2005 | PWH
Splicing for us has been a rough go as we haven't really found a tool that works well/fast. We have a few different machines = different feeders. They all react different to a splicing "style". The best so far is a crimp tool that crimps a brass s
Electronics Forum | Wed Jul 26 14:40:28 EDT 2006 | FredC
I just checked a hand full of scrap nozzles and the scuffing is usually on the right or left of the needle. If you have the cross pin facing you and looking down on the nozzle most of the scuffing or wear was on the left side, sometimes on both sides
Electronics Forum | Thu Mar 30 13:53:53 EST 2006 | PWH
We've had poor luck with leaders - inefficient, not cost effective for the price of the parts usually. In my opinion, your best bet is to over-issue parts to a scrap # that works for you (all feeders are different as are machine scrap rates). This
Electronics Forum | Mon Mar 05 18:04:43 EST 2007 | stepheniii
If it might go in a clean room you will want to look at if the system cuts the paper tapes. In the old days there was no vacuum at the cutter and around the machine would accumulate white dust from the machine cutting the tape for each component. The
Electronics Forum | Fri Jun 03 09:37:59 EDT 2016 | sumote
Same here. Buy it by the 2-pack at Staples. If the tape does not get used often we pull off about 5 inches and discard before we use it. The exposed tape between the cutter and the roll, and 1 rotation around the outside of the roll attracts dust and
Electronics Forum | Fri Sep 28 23:22:19 EDT 2007 | anne0405
SMT splice product(splice tape,splice cutter,splice tool,extender,stencil clean rolls and so on)with best quality and resonable price. pls visit http://www.khj.cn email:sales@khj.cn
Electronics Forum | Thu Jul 25 21:58:20 EDT 2002 | davef
How do you �physically remove the solder from the fiducal prior to disposing of the balance of the rail�? We don�t HASL our fiducals. Easier to see with vid head. If you need to HASL your fiducals, consider: * Disposing of the rails with your scra
