Electronics Forum | Tue Apr 21 02:28:54 EDT 2015 | dinhhuunam
Juki GL-1.... Any thoughts? I'm New to the > industry and I'm trying to buy a new screen > printer. I have two in mind, DEK and Juki. Hi Sir, I'll advise you the SJ INNOTECH Vision Screen printer Best Solution & Service for You Model HP-520S Hi
Electronics Forum | Tue Sep 29 01:51:37 EDT 1998 | Earl Moon
| I'm going to purchase a screen printer. | I've looked at the SMTech/Sigma 500 (also called Quad AVX500). | Has anyone any comments to this machine or production experience? | Anything would be appreciated. | I'ld like to hear any other type of ma
Electronics Forum | Tue Nov 20 18:56:19 EST 2018 | dekhead
If always on... you will need to write product file as edge justified, and position stencil properly before auto-clamping takes place. If always off... you will need to write product file as center justified... and position stencil and acknowledge st
Electronics Forum | Tue May 29 08:37:52 EDT 2018 | bukas
screen alignment chase clamp state is ON, it can be turned OFF but when I get out of diagnostics machine turns them ON again. Tooling is set to magnetic, and on other machines I have chase clamps are not energized all until board is in machine and st
Electronics Forum | Wed Jun 29 10:26:58 EDT 2011 | remullis
I've been using 29x29 framed screens for years. I have a company that has come up with a adapter that would mount in my screen printer and utilize just the foils of screens. It basically fits and is clamped into the adapter. I am struggling with floo
Electronics Forum | Thu Dec 16 06:06:52 EST 1999 | Stefan
Check the print gap and check the clamp edges, sometimes the clamps is damaged causing a distance between the PCB and the screen. Good luck
Electronics Forum | Wed Jan 24 09:52:50 EST 2007 | electronhose
Sounds like you need a support pallet to accommodate the narrow side clearance. Several pallet houses made pallets that work in screen printing that have flush board edge clamps that hold the board in the pallet yet allow the stencil to come all the
Electronics Forum | Tue May 29 17:24:28 EDT 2001 | hussman
OK, I have a new product being tossed over "the wall" that has a flex circuit layered into a standard FR board and protrudes out of it. The flex circuit is 0.022" thick and is the 3rd layer of 6 layers. The total board thickness of the FR board is
Electronics Forum | Mon Mar 24 14:19:36 EDT 2008 | burb1999
I have a DEK ELA and here is what happens. I print a board after going through the step and it is a dead on print. Then, with another print it will be off in Auto mode (sometimes up and sometimes down, seems to just be up and down not left to right
Electronics Forum | Tue Mar 23 09:30:35 EST 1999 | Dan Hughes
Nancy, The mounting hole locations in most standard frames are the universal in both the screen and stencil industry, more over some of the newer machines clamp the frame in place. Most printers are very adjustable this way. If you were using a "qu
