Electronics Forum | Mon Apr 26 08:15:37 EDT 2004 | pjc
MPM uses a one-print-Mylar system, as do other printer mfrs. In this system there is a Mylar sheet attached to a frame that is secured over the printer table with the board on it. You print onto the Mylar. The table X-Y-theta manual adjustments are u
Electronics Forum | Mon May 03 20:17:40 EDT 2004 | Jacek
Try to check axis drivers - at the begining should be tactile. When you press RESET look on the screen - is there any change (position send from encoders) ?
Electronics Forum | Thu May 13 16:54:55 EDT 2004 | Kuru
I just installed a used Tactile sensor unit, Now it now reads error "Tactile Sensor sensor never closed". If anyone knows or seen this problem pls help. I have adjusted the flag on the photosensor.The photosensor appear to be functioning but the step
Electronics Forum | Fri May 14 12:40:03 EDT 2004 | Kuru
My switch is good, I can check the switch and the two photo sensors on the input test screen. They are turning on and off.I can see it no the board too. When I start up I can see Tactile unit come down so I know pneumatics portion is good. I am still
Electronics Forum | Tue Nov 19 12:36:01 EST 2013 | youngbuck
DEK Infinity-Does anyone have any information on why the automatic screen changer would load the same screen in a different position everytime you load and unload? We constantly have to do a search step for the fiducial and most of the time it will e
Electronics Forum | Thu May 19 09:16:52 EDT 2005 | nelly
Check when you set up the board that it is positioned in the centre of the table. When the calibration is carried out the table drives away and then returns to capture the fiducial, if there is not enough travel left in the actuators then this is th
Electronics Forum | Sat Sep 06 07:20:37 EDT 2014 | gascon5383
I have an issue with this DEK printer our company has been having for over a year now. It seems that DEK can’t narrow down what the issue actually is as well. The printer is a DEK Horizon 03i 09 SP13 P02. We are having an issue with the camera.
Electronics Forum | Fri Aug 28 11:39:23 EDT 2015 | dlee87
I have an issue with this DEK printer our company > has been having for over a year now. It seems > that DEK can’t narrow down what the issue > actually is as well. The printer is a DEK Horizon > 03i 09 SP13 P02. We are having an issue with
Electronics Forum | Wed Oct 08 10:54:35 EDT 2008 | stepheniii
Check with your stencil house. At one time I used a Panasonic screen printer with the fiducial camera looking at the top of the stencil. The stencils are cut from the bottom so the fiducials had to be cut all the way through. And the stenicl house wo
Electronics Forum | Wed Jul 12 16:39:59 EDT 2006 | SWAG
Can anyone help point me in the right direction on fixing problems related to the following Universal GSM2 errors?: 1) Axis head 1 Z position following error during Move Absolute command. 2) Axis head 1 Z error not recognized during Move Absolute
