Electronics Forum | Fri Dec 14 19:56:40 EST 2018 | denisss
Good afternoon, the problem gives an error vision gantry x, an error occurs after the camera approaches the car wash and hits the piston, what could be the matter? are there any real specialists gives an error after a certain working time of 40 minut
Electronics Forum | Mon Apr 26 08:15:37 EDT 2004 | pjc
MPM uses a one-print-Mylar system, as do other printer mfrs. In this system there is a Mylar sheet attached to a frame that is secured over the printer table with the board on it. You print onto the Mylar. The table X-Y-theta manual adjustments are u
Electronics Forum | Thu Apr 29 14:41:12 EDT 2004 | pjc
OK if the paper is transparent and you can adjust the table X-Y-Theta under the paper- without moving the paper - the align with the solder lands on the board. If you have a DEK or MPM machine, the Mylar frame is like $300. I belive other printer mfr
Electronics Forum | Mon Apr 26 15:04:14 EDT 2004 | pjc
You are correct in understanding that the vision system comes into play for subsequent boards- to align them. Yes- if you missalign the first board and set the cameras to that board, all subsequet boards will not be aligned. Mylar is a thin polyester
Electronics Forum | Thu Apr 29 16:58:00 EDT 2004 | pjc
You should be able to get a one-print Mylar frame for the SMTech 90 machine from SigmaPrint, http://www.sigmaprint.co.uk Yes, with vision you store images of two features such as solder lands or fidicial marks from opposite corners of the board. With
Electronics Forum | Fri Feb 06 15:52:18 EST 2004 | pjc
SPM is superior in terms of technology and application. SPM has larger print area, up to 20� x 19", vs. 17.7� x 15.7� for the MicroFlex. MicroFlex is microprocessor controlled while the SPM has a PC. SPM can print down to 12mil (0.3mm) fine pitch no
Electronics Forum | Thu Mar 30 10:02:03 EDT 2017 | Bestglobal SMT
We have a 2008 DEK horizon 03i this machine has been a very reliable system. we are having an issue with the print being offset in the x .2mm I have run 4 different boards - same issue on all. same offset. i can print the board 10 times over and
Electronics Forum | Mon May 09 21:07:53 EDT 2022 | kurtiss
Currently we have a line running a MPM Accuflex. We are working on setting up a second production line and are in need of a new stencil printer. The two machines available within budget are a MPM Momentum and a Ekra X6. We have been happy with the MP
Electronics Forum | Wed Mar 27 13:47:24 EDT 2019 | whitelancer64
I am having an issue with aligning vision for solder paste inspection with the PCB in the Momentum machine. The SMT operators setup the profile on the machine, which I then import into Aegis CircuitCAM to add PCB locations. But when I export again, t
Electronics Forum | Mon May 13 13:45:33 EDT 2019 | whitelancer64
I am having the same problem with the MPM Accela solder paste printer machine. If the fiducials are adjusted for PCB alignment, the location of the paste is then wrong, and vision inspection fails. This is a problem for both pad preview inspection
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723
.gif)
