Electronics Forum | Mon Aug 03 07:14:38 EDT 2020 | bangir
Hi, How to adjust the table height of Screen Printing EKRA X5? Could you share me the Manual System Operation?
Electronics Forum | Fri Feb 16 05:39:56 EST 2018 | abo2016
we came across the following error this morning while working on the DEK 248 screen printer. Table in/out error message. Can we be assisted with fixing this please..
Electronics Forum | Wed May 09 08:48:51 EDT 2012 | leemeyer
Try going into the program definition screen and delete the permanent table top. Then shut down and reboot. The permanent table top will be re created upon reboot.
Electronics Forum | Tue Aug 04 04:20:36 EDT 2020 | bangir
Hi Chris, It's arround +/- 2MM. There was a gap if running pcb with thickness 1MM. The PCB position below the rail table.
Electronics Forum | Tue Aug 04 13:45:03 EDT 2020 | oxygensmd
There are one value for thickness during PCB-teach function which is the PCB thickness. The other one is the camera focus in machine option but it is a dangerous function because the camera focus is adjusted by raising/lowering table.
Electronics Forum | Wed Aug 05 07:38:17 EDT 2020 | bangir
Hi Cris, Yes, The PCB thickness is 1mm. the PCB position below the rail thickness when the table go up the print position. Please advice or do you the service manual book.
Electronics Forum | Thu Aug 13 19:23:06 EDT 2020 | kojotssss
Call +4 (Christian) Ekra screen printer specialist.
Electronics Forum | Tue Aug 04 01:55:29 EDT 2020 | cbeneat
How much adjustment is needed? Adjusting the snap off will get the PCB tighter/looser to the stencil. But this is only a 3 to -3 MM adjustment.
Electronics Forum | Tue Aug 04 22:26:38 EDT 2020 | cbeneat
So 1MM is the board thickness in your program?
Electronics Forum | Wed Aug 05 06:34:33 EDT 2020 | oxygensmd
Yes if you adjust the thickness to be thin than the machine raise the PCB more to the stencil - than the foil have better tension but it string out faster.