Electronics Forum | Tue Oct 07 13:01:48 EDT 2014 | charliedci
does anyone have experience with reflow of Micro SD cards to PCB@ lead free temps?
Electronics Forum | Sun Jun 30 20:46:20 EDT 2013 | kumar_antom
HI there, I am having problem on the solderability for the fine pitch lead on SD card holder on this pcb.Have tried different kind of temperature settings on the reflow but the problem still occurred.Pls refer to the attached pictures.And when i jus
Electronics Forum | Mon Jul 01 19:57:01 EDT 2013 | kumar_antom
And this process is using a kind of ceramic jigs..... Does this jig absorb much heat that does not dissipate enough heat to the SD card pins ? Thanks
Electronics Forum | Wed Jul 10 23:29:14 EDT 2013 | kumar_antom
HI guys, Problem solved.....reason is the SD card's location in on the fixed side of the reflow oven,i believe there is not much convection heat blown towards the component.... Pleased to hear if any rgds
Electronics Forum | Fri Feb 22 15:38:48 EST 2019 | tsauve
Anyone have experience (good or bad) directly reflow soldering microSD card (Pb-free) to PCB. asking for a friend :)
Electronics Forum | Mon Dec 06 13:54:01 EST 1999 | Andy Yates
Mathematically, measure the component offsets from nominal then calculate the average and the SD of the offsets in x and y. You can then use the following equation to calculate the CpK: CpK = (Process Width - Abs(Average offset)) / (3 * SD offset)
Electronics Forum | Mon Jul 01 11:29:02 EDT 2013 | hegemon
I am guessing a lead free process. From the pictures, I don't neccessarily see any issues, perhaps the leads have wicked up a little too much solder, making the joint look a little starved. But I think I see nice toe and side fillets. In the worst c
Electronics Forum | Mon Sep 23 01:42:35 EDT 2019 | sssamw
yes, socket on PCB, SMD type
Electronics Forum | Mon Jul 01 08:33:55 EDT 2013 | markhoch
A couple things to look at.. Are you using Pb-Free solder? What are the leads of the SD Connector tinned with? Do you have a thermal profiler to use to verify your oven profile? (If not, you may be able to ask a Sales Rep to come in and assist y
Electronics Forum | Wed Dec 01 15:07:16 EST 2004 | bdrobinson
Hey all, I am currently looking into switching from using Alcohol in our screen cleaner to Zestron SD301. I am confident that it will clean our stencils better, but the cost of Zestron is 3 times that of alcohol. Has anybody done any studies o
winsouce.jpg)