Electronics Forum | Tue Apr 02 17:22:50 EDT 2013 | microaide
That makes some sense. By knowing the coordinates of the leftmost and rightmost feeder, the others can be interpolated. As long as they are all the same type of feeder. But I still don't see how to configure an assortment of different types of vibrat
Electronics Forum | Fri Apr 05 14:17:11 EDT 2013 | leemeyer
I have no idea why this limitation would be programmed in. Like I said before there a lot of wierd quirks whith this software and you may have just found one. Pre-assigning will not help if the software sees a mismatch between the feeder plate and th
Electronics Forum | Thu Apr 11 07:45:44 EDT 2013 | leemeyer
I have never run across that error message before. Does the machine have Upward vision? Does this message only occur when trying to run programs that were generated by Autoprogram ? I think that I would create a new program with only 1 component, a r
Electronics Forum | Mon Apr 15 21:00:57 EDT 2013 | dman97
Hi, I have another problem. This time with a vintage 1995 GSM machine. Upon startup, I am seeing a part to pad LED tower time out. The GSM knowledge base says to change they relay at CR1 on the power distribution board. On this machine, the power
Electronics Forum | Tue Apr 23 13:43:29 EDT 2013 | dyoungquist
PCB breakaway tabs, such as the borders around panels, often do not have any metal on them. These would have no recycle value. Our local metals recycling company has now started to recycle PCBs, loaded or unloaded. They only pay $0.08 (USD) per po
Electronics Forum | Tue May 07 13:51:51 EDT 2013 | shankar2013
acceleration is set to lowest. Ribbon cables were replaced, theta motor replaced. I also see a message pop up just after F-MOT1-26/156:MOVFI: MOTOR TIMEOUT / F-AXIS-182:C-AXIS NOT properly out when expected / 25v reads 3V. Now all these messages
Electronics Forum | Fri Jun 14 05:49:32 EDT 2013 | rollon65
Hi all. I used a 5/16" white paper sticker to mark a reject PCB in a panel of 10. One of my my Quad 4Cs sees it O.K. and marks the PCBs reject. The other machine either shows them all reject or shows the marked one as good and the other 9 as rejec
Electronics Forum | Mon Jul 01 13:19:55 EDT 2013 | emeto
I always look for a toe fillet if the design allows you to. Many times the pad design is close or exactly the size of the leads which makes people to touch it up right away. I told them hundred times not to but...Luckily I have 3D x-ray and I can tel
Electronics Forum | Mon Jul 29 08:34:40 EDT 2013 | gallionc
I don't see an issue. As was mentioned before, it is what the customer wants. You could approach this from one of two ways. You could simply install the parts, clinch the leads on the opposite side for added mechanical strength and solder the parts
Electronics Forum | Mon Jul 29 19:39:57 EDT 2013 | hegemon
No problem running lead free without nitrogen. Careful profiling will take care of the soldering. Cosmetically, the Nitrogen reflow is superior for lead free, and we see much better wetting, better coverage of the PWB pads, and of course the smooth
.png)
