Electronics Forum | Mon Jan 18 17:58:09 EST 1999 | marc p
| I have a severe problem with flux residue being drawn up the vent ducts of my reflow oven. This residue reaches a critical mass then begins to flow down the ducts and becomes very messy. I run a no-clean process and use IR oven. Has anyone else o
Electronics Forum | Thu Jan 14 23:38:34 EST 1999 | Chris G.
| I am experiencing a problem with a surface mount coax connector that over time pulls loose from the PWB. The connector has 4 small gold plated leads and we are soldering it to a flash gold board. A cable plugs into the connector and puts some con
Electronics Forum | Thu Jan 14 22:19:34 EST 1999 | Chris G.
| I need to buy modestly priced pc layout software for very infrequent use for very simple microwave and analog surface mount multi-layer boards. Can any one recommend a software package which is easy to learn, runs on a Windows PC and interfaces wit
Electronics Forum | Wed Jan 06 14:54:42 EST 1999 | Steve Gregory
| Steve, | | So good to see you back, old boy! Where ya been???? | | Chrys Hi ya' Chrys! Oh, I've been around...just haven't had a whole lot of time like I used to. The place I'm working at now is a start-up (as you may know, I think I ment
Electronics Forum | Wed Dec 23 03:33:14 EST 1998 | Charles Stringer
Can anyone recommend a solder stop that can be applied by our PCB supplier. Our current material form Tamura Kaken is causing problems. The material should be capable of withstanding 1 Surface mount IR reflow cycle and 1 wave solder cycle. We need t
Electronics Forum | Thu Dec 17 10:04:28 EST 1998 | Chrys
Necessity is the mother of invention... The other day I loaned my last bit of high-temp solder to a co-op and never saw it again. Then I had to run a profile and I was in a pickle with no solder. So I ran out to the local Radio Shack to see if the
Electronics Forum | Wed Dec 02 09:28:24 EST 1998 | Dave F
| Hi, | I'm looking for a small batch convection oven that will replace the dryer section of a batch ultrasonic cleaning machine to dry off excessive water from washed PCB's, | any suggestions for particular suppliers, will be appreciated. | Jack |
Electronics Forum | Sat Dec 05 17:41:07 EST 1998 | Earl Moon
| | | Have either one of you seen or used a SRS machine? I had | | | one in for a demo - very impressive. The original model was | | | a little too awkward for production to use, however, the newer | | | model is a little easier to use. The big
Electronics Forum | Mon Dec 07 18:52:23 EST 1998 | Jason
| | | | Have either one of you seen or used a SRS machine? I had | | | | one in for a demo - very impressive. The original model was | | | | a little too awkward for production to use, however, the newer | | | | model is a little easier to use.
Electronics Forum | Wed Dec 09 18:52:58 EST 1998 | Jason
Erwin, I have a question for you. Are there any dross recycling facilities in the Phillippines? How much do they pay per lb/kg? What is your cost of solder? If you recover 75% good solder from your waste, you can easily cut your cost of soldering
.png)
