Electronics Forum | Wed Feb 20 15:20:34 EST 2013 | hegemon
Depending on your requirements, you could range from a hair dryer, heat gun, toaster oven, hot plate, on up to digitally controlled surfaces and convective systems. You'll have to gauge for yourself whether you are just trying to add some heat energy
Electronics Forum | Thu Feb 28 10:40:56 EST 2013 | rway
I have been doing this since day one of getting the AOI. It just seemed logical. I don't know what type of AOI you have, but what I have found works best is to use solder inspection to catch parts that are loaded into a no-load location. Move the
Electronics Forum | Tue Mar 12 07:46:26 EDT 2013 | ngineer
bobpan, It only happens with this program. CC ver 7.54, IVC V 3.05 If i leave CC out of it, and edit the sequence using the HHT, it sticks. but if i download from the assembler to CC, it's messed up. if i then fix it in CC, the minute i save
Electronics Forum | Thu Mar 28 20:57:22 EDT 2013 | ericrr
I have my cell phone wired up for "RSS feeds". Yesterday at work, I saw on my cell phone someone ask "KE750 & KE760 cannot recognation part standing" (spelling mistake uncorrected) I am not sure if this answer is correct as I can not find the thread
Electronics Forum | Tue May 21 09:06:03 EDT 2013 | hussman
Delta-T in reflow generally means 2 things - difference in temperature on a product or difference in temperature of your oven. Delta-T on a product is what are your hottest and coolest areas on the board. Larger parts toward the middle of the boar
Electronics Forum | Fri Jun 14 12:00:10 EDT 2013 | rgduval
Is this a new assembly/new test fixture/program? Or is this an existing assembly that is suddenly exhibiting this failure? Capacitors measured in circuit will not necessarily measure their correct values. Active components in circuit will be affec
Electronics Forum | Mon Jul 15 19:18:51 EDT 2013 | microaide
Does anyone know how to make the vision alignment work on a Quad 4C? What I mean is make it work right, and reliably. I know how to define the component for inspection (lead pitch, lead count, dimensions, tolerances, etc.), and I know how to set ligh
Electronics Forum | Mon Jul 22 12:43:31 EDT 2013 | microaide
I don't think it is a loose camera lens. We are actually off on the position of the Z-rod. It's not just the camera position that is off. We really can't change nozzles because the z-rod misses the hole in the nozzle changer. We have repeatedly clea
Electronics Forum | Wed Aug 14 18:19:09 EDT 2013 | jlawson
Generally the heller exl range has issues in cross profile, some machines more than others. I have see as bad as 15 deg c and as low as 5 deg c ranging from entire length to a few zones. They never match the specification in reality. The markiii is
Electronics Forum | Wed Sep 11 18:01:27 EDT 2013 | huske
I've had that issue before, here's how you fix it, or at least it worked for me. Also assuming you didn't destroy a shaft, which should be obvious. Follow the flexible vacuum tubes to the top of the hydra shafts, you should see a red light below the