Electronics Forum | Wed Apr 12 08:27:37 EDT 2006 | jdengler
aj What exactly is the reliability issues? Rejects? Missing components? Poor alignment? Jerry
Electronics Forum | Wed Apr 12 06:40:11 EDT 2006 | aj
All, I continuosly have reliability issues when placing a SOT363 device. I have Fuji CP6 and CP4 placement machines. The part data has been analysed down to the finest detail but it is still hard to maintain any consistency. Anyone else have simi
Electronics Forum | Sun Jun 07 19:16:54 EDT 2015 | linux
Hello everyone, I'm looking for help with placement issue on our cp6 Fuji. On occasion we have to adjust co ordinates on the x and y axis usually about 0.12mm. Ball screw was replaced did not fix issue. Anything else we could try. Thanks everyone
Electronics Forum | Wed Apr 12 09:29:11 EDT 2006 | aj
Poor alignment, I think I might have it sorted but feel free to give your advise
Electronics Forum | Wed Apr 19 10:47:08 EDT 2006 | FredC
That is a small part. What nozzle is normally used a 1.0 or 1.3mm.
Electronics Forum | Thu Jun 11 07:26:20 EDT 2015 | linux
Think you right, not enough to be worried about. Thanks for all your help.
Electronics Forum | Thu Jun 11 03:59:00 EDT 2015 | linux
Sr Tech. Thanks for reply, We don't have the same issue with other cp6, was wondering was there anything else we could check?. Thanks again.
Electronics Forum | Wed Nov 04 10:31:25 EST 2009 | vetteboy86
I'm not familiar with a puff off setting. I have tried some different things including release delay to shut the vacuum off before the nozzle lifts in the upward direction. I tried to minimally overstroke the part hoping the paste tension would over
Electronics Forum | Wed Apr 12 09:33:10 EDT 2006 | jdengler
We had a similar problem and needed to slow the cam speed. The surface of our component was rough so I suspect we did not get a good seal for the vacuum and the component was drifting on the nozzle after the camera. Jerry
Electronics Forum | Sat Apr 15 16:49:53 EDT 2006 | ausajid
hi we had also the same problem a time ago on the said package. we have taught his legs as 1, 3 and 5 instead of 1, 3 and 4 or 6. after doing this 98% problem solved. try this method...
