Electronics Forum | Mon Dec 17 12:06:58 EST 2007 | pjc
5 Steps to Eliminate Bridges: 1. Establish (wave) Parallelism First and foremost, you must establish board-to-wave parallelism. This is the prerequisite to any wave solder process control. For an understanding of the power of this approach go to ht
Electronics Forum | Wed Sep 18 14:12:40 EDT 2013 | pjchonis
Hello Bachman. SAC305 is the most common lead-free solder alloy, not only for wave soldering but also selective. Most of our selective customers (especially automotive) are using SAC305. What is more important than the alloy to consider is the flux
Electronics Forum | Thu Nov 17 08:57:39 EST 2005 | russ
No clean and foam fluxing is not a very good process from my experience. I know that the flux manufacturers claim that they are suitable but I am not sure what "suitable" means. I would bet that you have very inconsistant flux coverage. How often
Electronics Forum | Tue Aug 28 11:12:23 EDT 2007 | grics
This is what I was thinking, but I am being beat up pretty badly by the selective solder. Ambient temperature is anywhere in the the neighborhood of 76 - 80 degrees F. I am not sure of the RH, but I wouldn't think that would be my issue... One of
Electronics Forum | Thu Nov 17 21:46:48 EST 2005 | C. Kolokoy
With DIP type components, a sub-par fluxing method (foaming a no-clean), and a chip wave where one is not needed are formulas for bridging and insufficient wetting. If you have SMD's on the wave solder side of the board greater than 0603, and no SOT
Electronics Forum | Thu Nov 17 20:23:14 EST 2005 | cangly
Hi Russ, We control the gravity of flux each 8 hours and will mix thinner to balance it if any.. Do we need more any action for this.. Thanks for your advices.
Electronics Forum | Thu Nov 17 03:34:51 EST 2005 | cangly
Hi, We have a board with over 100 chips (mixed size) and some long Connector DIP through out Wave solder with many issues of no solder and solder bridge, (using clean flux with bubble fluxer and Kester solder bar). Currently we tried to reduce the de
Electronics Forum | Fri Dec 06 18:13:15 EST 2002 | slthomas
We only have solder balling problems in the interface of the pcb with the selective soldering pallet. All other boards (single, and double sided glue and waved alike) are fine, so I'm not thinking this is going to follow the normal path for resoluti
Electronics Forum | Wed Jul 30 16:16:19 EDT 2003 | swagner
What is the industry standard for wave and selective solder PPM defect rate for a world class facility, any responses are appreciated.
Electronics Forum | Tue Dec 17 08:38:30 EST 2002 | Randy Villeneuve
Jim, In most cases if you can eliminate a process you will save money. With that in mind, an all surface mount or all through hole design is prefered. There are alternatives to that rule, like hybrid designs that can be pin and paste soldered. It al