Electronics Forum | Fri Nov 14 10:40:35 EST 2014 | eniac
I use a two machines from EBSO, Germany. It's a machines with PCB carrier, so, solder pot is fixed. I'm fully satisfied with this equipment, but I use only wettable nozzles. If you would like to buy a new machine, not in used condition, EBSO will be
Electronics Forum | Fri Jun 23 12:54:53 EDT 2017 | guts1872
We are having issues with top fill and dropping pins on Molex connectors with our KISS 101. Unfortunately we do not have a pre heater and bottom side pre heat with our nozzles is not satisfactory. Most of the issues occur when using a no clean proces
Electronics Forum | Fri Mar 17 10:19:30 EDT 2023 | previnmoore
Hello, The selective solder has went to the end and gotten stuck trying to figure out why?
Electronics Forum | Fri Mar 24 15:43:04 EDT 2023 | previnmoore
ok that works for me
Electronics Forum | Fri Mar 17 12:00:52 EDT 2023 | previnmoore
Its the kiss 103 selective solder machine. The end of the travel, it's the x axis. when i tried jogging it nothing happens just makes a noise. Thanks for responding.
Electronics Forum | Fri Mar 24 15:01:47 EDT 2023 | previnmoore
sorry for the response taking so long, got wrapped up with another machine. It is the X axis.
Electronics Forum | Fri Mar 24 15:32:22 EDT 2023 | proceng1
Sir, I asked 3 or 4 questions. If it's easier, you can email me.
Electronics Forum | Fri Mar 17 11:27:58 EDT 2023 | proceng1
We need more info. What kind of machine? What do you mean by "went to the end"? Like the end of the travel? Which axis? Is there an error on the screen? What happens when you try jogging it? Maybe post a couple photos?
.gif)
winsouce.jpg)