Electronics Forum | Thu Jul 13 12:51:27 EDT 2006 | Carmichael
Does anyone hear have any first hand experience with these systems?
Electronics Forum | Mon Jul 17 11:40:20 EDT 2006 | Chunks
It's been a few years, but lack of preheat was my problem with this machine.
Electronics Forum | Mon Jul 17 14:54:57 EDT 2006 | finalassy
Preheat is a option that we use on almost all boards. We have the pillarhouse jade models.
Electronics Forum | Thu Jul 13 13:51:13 EDT 2006 | George
I got some info about it last year. I could not justify ROI since this machine was way too expensive (same thing with Vitronics Selective machines). You need to see if this machine will increase your throughput or not depending on your products. Al
Electronics Forum | Fri Apr 22 14:28:38 EDT 2005 | Gary Goldberg - PROMATION
Low end selective laser soldering systems are limited to what types of soldering can be performed. I have read through the previous comments and find that most have commented on earlier technologies (which do not offer the features today's system do)
Electronics Forum | Thu Feb 18 18:25:33 EST 2010 | tony_d
Hello Bryan, My recommendation is MIRTEC by far. We checked out several machines and narrowed the selection down to two, YESTech and MIRTEC. We had an opportunity to work with both of these machines on our production floor. We found that the MIRTE
Electronics Forum | Thu Apr 21 10:25:44 EDT 2005 | Fred Saffer
A thorough analysis is in order because laser point-to-point soldering lacks the flexibility of the bottom sided miniwave systems. My experience showed that heating profiles could be grossly affected by color temperature and thermal mass. This can be
Electronics Forum | Fri Apr 27 17:51:26 EDT 2007 | chrisgriffin
It appears a disgruntled employee has sabatoged my Sapphire solective solder. Along with cut ribbon cables, I think some jumpers were removed from the system board. D.O.M: '98. I was hoping that some nice person could take a picture of the system b
Electronics Forum | Thu Nov 13 12:49:45 EST 2014 | dyoungquist
I have no experience running a "move the board" selective solder so can not compare the 2 methods..... We have been using an RPS Rhythm "move the pot/nozzle" system since 2008. We are using it solder thru hole components onto boards that often have
Electronics Forum | Mon Apr 25 10:17:22 EDT 2005 | pjc
Here's another supplier: http://www.seicatestsolutions.com/pages/24/A30-Firefly-Solder-Station.php FYI: Contax is a rep firm that sells the MTA system
Electronic manufacturing services - electronic design, development and manufacturing. Circuit board design, prototyping, FPGA services, signal integrity and simulation, pcb assembly. Factories in California USA and Malaysia.
Manufacturer / Consultant / Service Provider
3240 Scott Blvd
Santa Clara, CA USA
Phone: +1 408 980 0400
