Electronics Forum | Thu Jul 02 11:50:48 EDT 2009 | davef
You should be able to use the wave solder flux that you currently use in your routine operations. Check with your flux supplier for recommendations.
Electronics Forum | Fri Feb 08 10:52:24 EST 2019 | roblackey
BLT 31-41 "No Clean Selective Flux For Aerospace" On a Versaflow 3/45 Atomises well, good hole penetration, good wetting, cleans off well in the solvent cleaner. Use for SN100C, SA0307, and 60/40.
Electronics Forum | Sat Jun 24 07:23:06 EDT 2017 | tch
You will need to preheat the boards for a lead free selective solder process. A preheat module is critical for any wave or selective solder process, if you don't get the board preheated properly the solder is going to resist flowing to the top of the
Electronics Forum | Fri Mar 17 10:19:30 EDT 2023 | previnmoore
Hello, The selective solder has went to the end and gotten stuck trying to figure out why?
Electronics Forum | Fri Mar 24 15:43:04 EDT 2023 | previnmoore
ok that works for me
Electronics Forum | Fri Mar 17 12:00:52 EDT 2023 | previnmoore
Its the kiss 103 selective solder machine. The end of the travel, it's the x axis. when i tried jogging it nothing happens just makes a noise. Thanks for responding.
Electronics Forum | Fri Mar 24 15:01:47 EDT 2023 | previnmoore
sorry for the response taking so long, got wrapped up with another machine. It is the X axis.
Electronics Forum | Fri Mar 24 15:32:22 EDT 2023 | proceng1
Sir, I asked 3 or 4 questions. If it's easier, you can email me.
