Electronics Forum | Thu Jun 25 11:11:13 EDT 2009 | bruna
Hello, I want to hear some experience about selective soldering for PCB using nozzle plate and screens Do you have solder defects? bridges and insufficient soldering? How do you combat that? and about the screens you have good quality? What is the f
Electronics Forum | Tue Dec 03 18:51:57 EST 2019 | kylehunter
Hi all, We are having a confusing defect with one of our client's boards. It is a large board, 30" x 12". The client supplies the LEDs, they are cheap overseas diodes, and it is not uncommon to have reels with the packaging torn. We have w
Electronics Forum | Thu Dec 09 04:53:36 EST 1999 | Glen brain
Hi, It is wavesoldering defect, in single- sided copper board, using alcohol-based rosin flux. It is not a bridging between the protruding leads but a metallic (I think, it is solder) link, varies in dia./thickness, connected the basement of solde
Electronics Forum | Mon Dec 06 06:06:44 EST 1999 | Glen brian
Recently, my plant met the problem of bridging, a metallic link, lying on the solder mask and joining nearby joints. It is very diffcult to observe by our inspector and may be only discovered with ICT testing. This defect ocurrs randomly around the
Electronics Forum | Mon Dec 06 09:28:11 EST 1999 | Dave F
Glen: So that's this metal? Is it in the area of PTH or SMT solder connections? Etc, Etc. Assuming its near connections where pasted is reflowed ... Reflow defects, bridging: misplaced components, high placement force mushrooms paste, too much p
Electronics Forum | Mon Dec 10 13:26:40 EST 2012 | dyoungquist
We are using our selective solder machine to solder a backplane with sixteen (16) 4x48 pin 0.080" connectors. Our first pass yield is about 85% meaning that 85% of the connectors come out with no bridges. Not quite as fine pitch as your connector a
Electronics Forum | Thu Dec 06 12:37:14 EST 2012 | deanm
We are having difficulty with bridging on a 2x50 pin 0.050" fine pitch connector using our selective soldering machine. It usually bridges at the end of the row, but sometimes it bridges all the pins together as it drags across (solid bridging). I
Electronics Forum | Fri Dec 07 13:31:09 EST 2012 | kenkay
We had a similar issue and it was fixed by trimming the connector so there was barely enough lead protrusion through the board to show a discernible lead. We had to get a special plate and small machine to cut the connectors, but we haven’t had a bri
Electronics Forum | Fri Jun 29 12:47:25 EDT 2012 | deanm
We are experiencing widely varying First Pass Yields for selective soldering. Some boards are near 100% while others are less than 50% depending on the pitch and general complexity of the board. Question: If you are running 100 boards through your s
Electronics Forum | Thu Apr 14 13:49:34 EDT 2022 | winston_one
Thank you for reply, Stephen. No, As I wrote it was leaded process. I heard that it is possible with lead free solder at higher temps an dwell time. At NPL Defect Database I've find this case wich looks exactly the same: http://defectsdatabase.npl.co
.gif)
