Electronics Forum | Thu Jan 06 17:20:09 EST 2011 | dyoungquist
Check out this article about nitrogen and soldering: http://www.tequipment.net/pdf/Hakko/TN00000022.pdf
Electronics Forum | Fri Mar 24 15:01:47 EDT 2023 | previnmoore
sorry for the response taking so long, got wrapped up with another machine. It is the X axis.
Electronics Forum | Fri Mar 24 15:32:22 EDT 2023 | proceng1
Sir, I asked 3 or 4 questions. If it's easier, you can email me.
Electronics Forum | Fri Mar 17 11:27:58 EDT 2023 | proceng1
We need more info. What kind of machine? What do you mean by "went to the end"? Like the end of the travel? Which axis? Is there an error on the screen? What happens when you try jogging it? Maybe post a couple photos?
Electronics Forum | Fri Mar 17 14:59:50 EDT 2023 | proceng1
OK, does your axis screw have the flex coupler or the magnetic coupler? Which axis is it? Did you turn off soft limits? If it's out of range, soft limits won't let it move by controls. I need to know which axis before I can get too far into this. I
Electronics Forum | Fri Jun 29 12:47:25 EDT 2012 | deanm
We are experiencing widely varying First Pass Yields for selective soldering. Some boards are near 100% while others are less than 50% depending on the pitch and general complexity of the board. Question: If you are running 100 boards through your s
Electronics Forum | Tue Feb 26 14:39:19 EST 2013 | eniac
Hi, guys. Does anyone use a EBSO selective soldering machines? Can you write your parameters for two rows connector? Thx!
Electronics Forum | Wed Apr 13 12:10:47 EDT 2022 | winston_one
Hello! We have a strange effect. Some pads of big trough-hole DDR slot just dessapear. Initialy it was soldered with selective soldering process (leaded, 290 degrees, ImSn finish, very short storage). Then some connectors with poor barrel fill we hav
Electronics Forum | Thu Jul 13 12:51:27 EDT 2006 | Carmichael
Does anyone hear have any first hand experience with these systems?