Electronics Forum | Fri Apr 13 14:51:01 EDT 2001 | Mike R.
Some Selective wave solder jig designer milled down the jig in one depth which is based on the thickest part on the bottom side of the board. This will create problem on the warpage on the jig due to the heat coming from the wave soldering machine. I
Electronics Forum | Mon Apr 09 07:12:17 EDT 2001 | Reg
I was wondering if anyone could advise me as to the thickness of a selective jig for wave solder. We currently run with a difference of ~6.7mm from the base of the jig to the base of card which to me seems too deep but this is what our jig manufactur
Electronics Forum | Fri Apr 13 19:38:28 EDT 2001 | Mike R.
I'm in Anaheim Area, if any body needs help for SMT Carrier Plate, Print Plate, Solder wave jig/Pallet and Assembly jig, Please send me an e-mail. miker228@cs.com
Electronics Forum | Tue Apr 10 10:10:03 EDT 2001 | Rob Fischer
Obviously the less mass in the wave the better. There will be less heat sinking and less push on the solder. Pallet thickness is typically a function of the tallest component on the board. If the board has one component that is tall but small in a
Electronics Forum | Wed Jan 12 21:37:04 EST 2005 | KEN
How thick is this pallet? 6mm, 8mm, 10mm? I would look at: Make sure you're pot height is correct (lead clearance). If you are burrying the pallet in the fountain, your going to "push" a large volume away. The solder "push" should not plow over t
Electronics Forum | Wed Dec 07 08:15:29 EST 2016 | anhsang38
Hello everyone My company have just bought a new Wave Soldering. Therefore, i want to know how to design the pallet for this machine. Does everyone have pdf document that relative the structure of Pallet. Thank you so much.
Electronics Forum | Wed Dec 07 09:20:27 EST 2016 | sumote
If you have some budget left over from buying the machine, contact the guys at Pentagon EMS. They build a bullet-proof wave pallet. They can make a board specific, for each assembly, or a generic-adjustable one that can be used for most boards. I can
Electronics Forum | Wed Dec 07 10:40:59 EST 2016 | davef
Does your new machine require the use of pallets? Some do not. If so, consider these suppliers to help with your pallet: * Asahitec stencils pvt ltd [http://www.smtnet.com/company/index.cfm?fuseaction=view_company&company_id=52967] * Stentech [http
Electronics Forum | Wed May 03 09:25:45 EDT 2017 | rob
Durastone pallets, we use lots of precision ones for selective wave soldering. An utter nightmare to machine - hideously fibrous. We use http://www.globaldatum.com/ for ours.
Electronics Forum | Fri Apr 28 10:50:26 EDT 2017 | emeto
Hello experts, Here is my problem: I have a board that has smt parts on one side and TH parts on the other. We designed special pallet for wave, but the pallet itself is 15mm thick, so we are still seeing some defects. Have any of you tried to find
