Electronics Forum | Thu Jul 13 12:51:27 EDT 2006 | Carmichael
Does anyone hear have any first hand experience with these systems?
Electronics Forum | Mon Jul 17 11:40:20 EDT 2006 | Chunks
It's been a few years, but lack of preheat was my problem with this machine.
Electronics Forum | Mon Jul 17 14:54:57 EDT 2006 | finalassy
Preheat is a option that we use on almost all boards. We have the pillarhouse jade models.
Electronics Forum | Thu Jul 13 13:51:13 EDT 2006 | George
I got some info about it last year. I could not justify ROI since this machine was way too expensive (same thing with Vitronics Selective machines). You need to see if this machine will increase your throughput or not depending on your products. Al
Electronics Forum | Tue May 11 08:33:55 EDT 2004 | pjc
here are some selective soldering system suppliers: http://www.seica.com/en2/a30firefly.html http://www.speedlinetech.com/electrovert/selectra.aspx http://www.myselective.com/itf/mys/homepage.nsf/web/index.html http://www.seho.de http://www.
Electronics Forum | Thu Feb 18 18:25:33 EST 2010 | tony_d
Hello Bryan, My recommendation is MIRTEC by far. We checked out several machines and narrowed the selection down to two, YESTech and MIRTEC. We had an opportunity to work with both of these machines on our production floor. We found that the MIRTE
Electronics Forum | Fri Jan 23 16:11:38 EST 2015 | rgduval
Charlie, For the 300 cylinder (the largest Airgas sells), it's going to cost about $66/cylinder for the gas (plus delivery charges). They also charge a $99/year lease for the cylinder. Based on those costs, and a low-end N2 generator system that I
Electronics Forum | Fri Jan 23 12:34:28 EST 2015 | dyoungquist
Our nitrogen generator and an air drying unit came with the selective solder machine when it was purchased new in 2008 as a package deal. We originally were feeding the system with air that was not properly dried. That lead to some maintenance cost
Electronics Forum | Mon Aug 24 18:45:11 EDT 1998 | Steve Evers
| We are looking at implimenting a bar code system for a SMT | production line. To start we are looking at label printer/applicators. Are there any other companies that we should consider besides Zebra and Imtec?? Thanks for your input. | John If
Electronics Forum | Tue Aug 25 21:01:45 EDT 1998 | Peter
We use an Intermec 3240 Thermal transfer printer and print on polyimid label material that survives the reflow and wave solder (top side only) process without turning black. Labels run around 3-4 cents per depending on the size (We found Imtec label
Electronic manufacturing services - electronic design, development and manufacturing. Circuit board design, prototyping, FPGA services, signal integrity and simulation, pcb assembly. Factories in California USA and Malaysia.
Manufacturer / Consultant / Service Provider
3240 Scott Blvd
Santa Clara, CA USA
Phone: +1 408 980 0400
