Electronics Forum | Fri May 29 20:15:15 EDT 1998 | Steve Gregory
Whoo-doggies Jason, you said a mouthfull!! (GRIN) Anyways, 'member what I said about me being a pack-rat? Guess what? I found some documentation that I've had for a while that does document the self-alignment forces that goes on when reflowing. I ha
Electronics Forum | Fri May 29 13:42:34 EDT 1998 | Steve Gregory
Hi Jason! I can probably find something documented for you, but the easiest way to convince your QA people is just to show them. If you have a board around that has some 1206 locations all in a row, print the board with paste and then plac
Electronics Forum | Fri May 29 16:12:11 EDT 1998 | Jason Gregory
| Hi Jason! | I can probably find something documented for you, but the easiest way to convince your QA people is just to show them. | If you have a board around that has some 1206 locations all in a row, print the board with paste and the
Electronics Forum | Tue May 19 13:53:53 EDT 2015 | dyoungquist
Parts will self align using Pb free paste as well. If your parts are not self aligning with Pb free paste, you have a problem with either your paste or the oven profile you are using.
Electronics Forum | Fri May 15 08:18:17 EDT 2015 | emeto
We all agree that you need to have your machine fixed. It probably needs calibration. Using Lead paste will help the parts to self align in the oven - however your misplacement should cover at least 50% of your pad. Pb free paste will not self align
Electronics Forum | Wed May 02 09:28:20 EDT 2012 | almoore
The surface tension of lead free solder alloys doesn't self align as well as it does with leaded alloys. Taking the guesswork out of alignment would negate the need for expensive split vision systems and make the parts hand reworkable.
Electronics Forum | Tue May 01 20:39:41 EDT 2012 | davef
Good luck with that. A couple of things to think about ... * BGA self-align during reflow, just get 'em on the pads * Add a box [or four corner] legend on the bare board to help you position BGA
Electronics Forum | Wed Aug 22 09:17:15 EDT 2001 | steven
if do not have x-ray inspection machine, how to verify the 1st board out from the smt placer that the BGA is placed accurately onto the solder pads. the diameter of the solder ball is 1mm. could it self align during reflow?
Electronics Forum | Fri Nov 07 11:32:36 EST 2003 | Gabriele
we experimented round pad for 0402, it improves chip self alignment and reduce tomb stone effects. On 0603, half round shape also gave guud results. G
Electronics Forum | Thu May 14 16:09:49 EDT 2015 | hottchkisu
Hi All, > > On occasion we see components that > have gone through pick and place and are slightly > misaligned. Currently, operators manually adjust > these misaligned components to prevent reflow > failures. However, I am wondering if this >