Electronics Forum | Tue Nov 08 16:21:37 EST 2011 | nevercry14
Cannot zero set machine actuator problem need help.
Electronics Forum | Wed Nov 09 08:29:51 EST 2011 | nevercry14
Found y sterper motor not working .nthanks for the info.
Electronics Forum | Tue Nov 08 18:27:50 EST 2011 | dekhead
Not a lot of info; first thought is 12VDC - PSU, breaker, fuse http://www.dekhead.com
Electronics Forum | Mon May 12 11:59:12 EDT 2008 | vms
todd the best answer is this" don't use the dispenser it will waste to much solder paste" Harry
Electronics Forum | Fri May 09 14:56:37 EDT 2008 | markhoch
The paste dispensers work well as long as the humidity in your shop is properly controlled. If it gets too humid, and the paste gets "soupy", then it will take less air pressure to dispense it onto the stencil. Paste dispensers use a controlled, pre-
Electronics Forum | Tue Oct 28 14:18:41 EDT 2014 | tombstonesmt
Spoke to the maintenance manager, master password is the current date in reverse. For example : Today is 10/28/2014 so... 41028201 Level 3 should be pass3. Hope this helps.
Electronics Forum | Tue Nov 18 21:18:29 EST 2014 | sonavc
Thanks, I don't have change to try the Password Now my machine boot up and get " BLUE SCREEN " I screw up my windows NT. Does any one know who till service this machine, reinstall the software and application. I'm in Southern California , CA 92708
Electronics Forum | Sat Oct 25 13:36:39 EDT 2014 | sonavc
Hi everyone, hope you can help me with this machine I bought used and after it is set up , it runs good, home position. I can click the tab Start, and Setup. But I can't click the tab I/O , edit or system. Because, I think I can't log in the Level
Electronics Forum | Wed Dec 09 09:47:32 EST 2009 | dyoungquist
I am curious as to why you need to mix.... We use a 500g cartridge with air gun. Our process is remove the cartridge from the fridge, allow it to warm up to room temperature before inserting into air gun, then apply bead of paste to the stencil. N
Electronics Forum | Wed Jul 27 09:58:05 EDT 2011 | davef
Pressure printing systems Conventional stencil printing techniques have fundamental limitations as regards paste handling: The volume of paste available for printing is limited, so frequent replenishment is necessary Paste is difficult to c
