Electronics Forum | Sat Jul 07 08:36:33 EDT 2007 | davef
Look here: http://en.wikipedia.org/wiki/Semiconductor_fabrication
Electronics Forum | Fri Jan 19 07:07:47 EST 2007 | Peter
Steve, You've been here long enough to know about our Equipment Mart. Place a wanted ad, it's free, and dealers will contact you. There was a Philips llisted in December...
Electronics Forum | Sat Jan 29 04:59:02 EST 2005 | Grant
Hi, MYDATA's are ok for lower volume, and they are very flexible. If you only have 1 or 2 trays of components and are on a tight budget, then you can even place the trays on the Y wagon behind the PCB so you can get away without the tray wagon. Al
Electronics Forum | Wed Aug 21 14:35:16 EDT 2002 | Kovachik
We are a CM located in Eastern Canada. Looking for some used X-Ray Equipment. Would anyone be able to suggest some reputable used equipment dealers, preferably in Canada OR perhaps one of the board readers'companies would have equipment they are lo
Electronics Forum | Wed Nov 26 13:09:48 EST 2003 | haviland
Dmitry--Good afternoon. We are dealers in used and reconditioned assembly equipment, and can provide the radial insertion machines required for this application. Regards, Nick Haviland, Electronic Assembly Machinery Exchange, (WI & IL, USA) (262) 24
Electronics Forum | Thu Aug 21 14:23:56 EDT 2003 | kenBliss
In order to service your wave solder machine safely, the following needs to be understood. Ladling dross out of the machine and putting it in into a coffee can or similar is not safe and puts operators and other employees at risk. Protecting the se
Electronics Forum | Tue Jun 23 11:08:42 EDT 1998 | Russ Miculich
| Any ideas on what to buy? Only need to build surface mount protos, ability to rework. Is a rework station okay? | Will subcontract production after design is proven. Best bet is to get an Elite or OK Industries manual printer if you are not doing
Electronics Forum | Tue Jul 19 09:06:00 EDT 2016 | davef
We used to use those, back in the bad old times. basically, it's a router with a blade on it that is used to trim the leads of PTH components that are mounted on boards. Nasty process. Difficult to control. Messy, firing cut leads all over the plac
Electronics Forum | Thu Aug 02 21:22:15 EDT 2018 | davef
I need your input. What are your thoughts? Currently SMTnet is looking to improve process. It uses four different lists of categories that all are maintained and updated separately. A single LIST makes sense. Approaches to arranging the LIST being
Electronics Forum | Tue Apr 08 07:46:05 EDT 2008 | jdengler
Try all the used equipment dealers that advertise here. And post it in the Equipment Mart section. - Jerry
.gif)
