Electronics Forum | Tue May 02 07:19:29 EDT 2006 | billyd
Good morning all. I'm trying to find some help on my voiding issue on my lead free BGAs. I am using a Heller 8/2 zone oven, and using Qualitek solder paste. I had listened to a tech representing another solder company, who told me to make the joints
Electronics Forum | Mon Jan 25 13:42:35 EST 2010 | patrickbruneel
This is a post from another forum as a response from Bob Landman to a claim that he had no evidence to be concerned about lead-free in hirel applications (interesting read). See below and am sure many technetters will find this interesting **********
Electronics Forum | Wed Jan 17 15:13:24 EST 2007 | jaime39
When placing the part to be reflow try applying heat to the board from the secondary side until the primary side has a temperature of about 130 degrees celcius. Following this procedure it should minimize the heat exposure of the part being soldered.
Electronics Forum | Thu Oct 30 21:55:27 EST 2003 | johnwnz
Now I've checked the archives on this and found the starts of an answer but not much else, but then that posting was a while ago and I though there would be some more data now. So here's the question: who, if anyone is placeign Pb-free BGA's (ideally
Electronics Forum | Wed Jun 02 05:40:35 EDT 2004 | johnwnz
Is there not an issue with reflowign the SAC ball's in term's of drivign up the lead contect in a lead free joint that increases the risk of failure in them? certainly dramatically increases voiding... have some pictures of soem that a customer tried
Electronics Forum | Wed Nov 08 08:12:16 EST 2006 | jnaligan
hi... try evaluating eco solder paste Sn96.5/Ag3.0/Cu0.5 from Senju... output is good and i suggest your stencil's apperture ratio with the pad 1:1 when it comes to fine pitches...and BGA pads regards, janry
Electronics Forum | Fri Nov 22 17:53:55 EST 2002 | davef
Search the fine SMTnet Archives for background discussion on BGA voids.
Electronics Forum | Mon Feb 11 17:21:40 EST 2008 | larryd
What causes BGA voids over 25%? Have recommended profile for solder paste, hit 237C for 5 seconds and still get a void on 2% of specific BGA in various locations. BGA is FG676, 1mm pitch, on ImAg using lead free paste OM338 on a 6 layer FR4 PCB.
Electronics Forum | Mon Oct 21 03:52:38 EDT 2002 | Ben
I'm doing lead-free SMT of BGA with 450 micron ball. I found there are lots of voids under xray, there are around 2-3 voids in every balls. It is around 10% of volume ratio. I would like to ask if anyone know there is any standard of acceptable maxim
Electronics Forum | Sat Aug 21 02:37:56 EDT 2010 | horvath83
What would You recommend? PCB has 5 medium sized lead BGA packages on one side and huge lead - free BGA. On the other side among other elements of course there are 5 big sized lead - free BGA Quad Gigabit Pulse transformers. PCB plating: Ni/Au.
.gif)
winsouce.jpg)