Electronics Forum | Tue Aug 14 23:58:19 EDT 2001 | Glen Brian
We are using the new auto-dipping machine for LED solder dipping and dragging. The flux is water-soluble flux and the solder is 63/37 at 250 deg. C. Two weeks ago we exchanged the pot with new 63/37 solder. About a week, we found that the high level
Electronics Forum | Wed Sep 22 13:49:47 EDT 1999 | Claude Couture
The machine is a Universal 6796 DIP inserter. The driver card for the X axis burned a couple of resistors and a trace, probably a couple of power transistors too. I had a spare card and put it in. Now on powering-up the machine, the X-Y table move
Electronics Forum | Fri Sep 24 10:43:42 EDT 1999 | Ken Kkoyen
| The machine is a Universal 6796 DIP inserter. The driver card for the X axis burned a couple of resistors and a trace, probably a couple of power transistors too. I had a spare card and put it in. Now on powering-up the machine, the X-Y table mo
Electronics Forum | Fri Sep 24 13:44:06 EDT 1999 | Eric Lee Williams
| | The machine is a Universal 6796 DIP inserter. The driver card for the X axis burned a couple of resistors and a trace, probably a couple of power transistors too. I had a spare card and put it in. Now on powering-up the machine, the X-Y table
Electronics Forum | Fri Sep 24 20:33:44 EDT 1999 | Ron Gillam
| | | The machine is a Universal 6796 DIP inserter. The driver card for the X axis burned a couple of resistors and a trace, probably a couple of power transistors too. I had a spare card and put it in. Now on powering-up the machine, the X-Y tabl
Electronics Forum | Thu Nov 17 03:34:51 EST 2005 | cangly
Hi, We have a board with over 100 chips (mixed size) and some long Connector DIP through out Wave solder with many issues of no solder and solder bridge, (using clean flux with bubble fluxer and Kester solder bar). Currently we tried to reduce the de
Electronics Forum | Thu Nov 17 21:46:48 EST 2005 | C. Kolokoy
With DIP type components, a sub-par fluxing method (foaming a no-clean), and a chip wave where one is not needed are formulas for bridging and insufficient wetting. If you have SMD's on the wave solder side of the board greater than 0603, and no SOT
Electronics Forum | Wed Feb 22 19:22:57 EST 2012 | joeherz
Give some serious thought to what your service options are for one of these machines. Senju doesn't have a big presence here in the US and I'd want to know where a serviceman would need to travel from if you get into the deep stuff.
Electronics Forum | Tue Feb 21 16:38:18 EST 2012 | comatose
We finally can't avoid adding wave solder to our process anymore. For lead-free, medium sized wave I'm leaning towards mid 2000s senju units as the best fit. I've never run their equipment. Opinions? As a point of reference for our general capabilit
Electronics Forum | Mon Jan 11 01:44:29 EST 1999 | Erhard Hofmann
Does anyone know 2-pin DIP components? Who uses them, why are they in the DIP form and not simple axial components? Are they usually placed by hand or by modified DIP placement machines? Thanks for any answers, Erhard
