Electronics Forum | Mon Oct 07 16:07:22 EDT 2019 | ddfreeze
I have a silver aluminum z axis sensor that is not mounted, I need to know where it goes. The sensor has a picany rail type mount, triangular rail insert type. It is located in the board support nest area. Seems like it might go on the inside of the
Electronics Forum | Fri Jun 12 14:19:03 EDT 2015 | tdemon69
i have a up 3000 ultraflex. the lower half of the tactile sensor is stuck down. i have replaced the driver board, check wire down to drive board,check the fuse for power on the driver board.
Electronics Forum | Fri Jul 29 17:41:35 EDT 2016 | ddina
I appreciate your response. I kind of read about it, and made sure nothing sensor-wise is activated by mistake on the process of zeroing. Right now the machine is in this set up, and the rear rail is all the way to the back stop. So the sensor on the
Electronics Forum | Mon Sep 12 09:26:00 EDT 2016 | awhite
Our MPM Up2000 HIE is having a communication problem with any upstream machine we place in front of it...i.e. conveyor, board loader, etc. It all started when we removed a conveyor from inbetween it and a board loader, and hooked those machines up di
Electronics Forum | Mon Jul 30 10:22:57 EDT 2007 | swag
Sounds like your board stop sensor is not working properly so it's not seeing the y-stop/board edge when the board enters the center or the machine. You could try taking the camera cube cover off, jog the camera over a board then move the board back
Electronics Forum | Fri Sep 17 23:59:40 EDT 1999 | JAX
| | | HI everyone, | | | | | | We are using a Siemens ap-25 screen printer, in the past we have not had any problems with adhesive placement until a couple of weeks ago. It seems the x axis has decided that it should be set somewhere between .00
Electronics Forum | Mon Sep 24 07:38:01 EDT 2007 | chrispy1963
I never saw in any post if your machine uses the camera to find the board edge or if your machine uses the bottom front rail mounted board stop sensor. Also is this with only one particular job you run on this machine or is this happening with ALL
Electronics Forum | Thu May 09 10:37:35 EDT 2019 | slthomas
Disclaimer - I know nothing specific about MPM printers. First, a question - have you successfully printed or programmed a print cycle for any other board yet, or is this the first one? I ask because a board stop sensor error sounds like it could b
Electronics Forum | Mon Apr 24 13:23:37 EDT 2006 | pjc
Use the photo sensor to stop boards instead of the hard-stop. There is also an ultrasonic sensor upgrade. A little more robust than optical. Y Snugger Tooling upgrade is kind of pricey and they like to do that in the plant. But, I've known that upgr
Electronics Forum | Thu Apr 20 16:40:33 EDT 2006 | PWH
All our AP's have camera mounted board stop sensors (works like a conveyor sensor). You can also mount these sensors on or near the conveyor if you want. We do not have problems like you talk about. You should call MpM and ask them if it's possibl
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723
