Electronics Forum | Wed Sep 20 10:42:05 EDT 2000 | Erick Russell
Process control for Photonic soldering is based on the actual temperature of the component being reworked. If the desired temperature of the component for your process is 200C then that is the process temperature programmed. This is achieved by a cl
Electronics Forum | Tue Jul 28 13:27:31 EDT 2009 | davef
It's possible that there is limited application of "3M™ XYZ-Axis Electrically Conductive Adhesive Transfer Tape 9719" similar to your intended use. What do 3M™ application types say? Certainly high temperature soldering would make a mess of a piezoc
Electronics Forum | Tue Mar 08 15:55:08 EST 2016 | sarason
Also try monitoring your temperature profile with a temp sensor independent of the machine, maybe your heating element isn't spiking quite as well as it used to ? sarason
Electronics Forum | Wed Dec 10 16:14:37 EST 2014 | jimpat
The 300 degrees is the temperature as measured at the sensor. The actual air temperature just above your PCB may actually be much less. If the oven is properly calibrated then the 300 should represent air temperature at the board but I have seen ma
Electronics Forum | Sun Aug 02 19:47:16 EDT 2009 | isd_jwendell
Now that I've seen the pics... Soldering could work just fine. If you are going for large production then you could get copper discs cut and mounted in tape carrier ($$). This would make it very easy for automated equipment to assemble. Mounting a
Electronics Forum | Mon Aug 12 15:56:13 EDT 2013 | pjchonis
Vapor phase soldering systems by Asscon are characterized by special designed heating modules. The thermal mass of the heating modules is designed so that a completely delay-less and direct regulation of the heat/flow/energy transfer to the soldering
Electronics Forum | Tue Nov 01 01:36:27 EST 2005 | mki
Hi, I am looking for opinion about possibility to do BGA rework with SRT-FPD? This early model (before 2000) is equiped with "Variable Perimeter Heater" (VPH). For BGA rework, SRT introduced later "Summit" models with removable nozzles. I am wonderin
Electronics Forum | Mon Jul 11 17:49:53 EDT 2016 | davef
Measurement Specialties purchased RTD Company, Inc. [ http://www.meas-spec.com/rtd-company.aspx ] in October 2012 and has maintained the primary site and staff in Minnesota. We continue to be a technological leader in the design and manufacture of e
Electronics Forum | Thu Apr 05 09:17:40 EDT 2007 | itaig1
I have seen a method used where the pins on the connector are of the same materials as the thermocouple and the connector is connected via single strand wires of the same material to the PCB however the wires were spot welded to bare copper pads to r
Electronics Forum | Sat Mar 27 17:18:02 EDT 2021 | osfuco
Good evening, I am doing a project in which I want to measure air quality. I started the project with the ESP8266 NodeMcu board and three sensors, temperature (DHT22), VOC's (CCS811) and PM (PPD42). I have it all assembled with a breadboard and the