Electronics Forum | Mon Apr 08 13:09:48 EDT 2013 | microaide
I have set Maximum Sequence Steps Per Program Segment to 450 and Maximum Placements Per Program Segment to 200. I have two Quad IVc machines, with a separate central controller in each one. One machine has a waffle feeder and will have vibratory feed
Electronics Forum | Fri Feb 01 19:12:18 EST 2013 | marcelorotofrance
Hi, I have a QUAD 4C mk2. I taught pickups and places from HHT. If I test them individually (RUN STEP PICK/PLACE etc...) before building the sequence, everything runs ok. After the sequence was built, everything goes wrong. Every PICK or PLACE ends i
Electronics Forum | Wed Aug 25 19:35:48 EDT 2004 | russ
This is highly dependent upon your board, vision inspection, part rotation, part type, layout, number of P/Ns per (1 pers or 100 pers) feeder layout, optimization, nozzle changes, etc... all have significant impact on placement speed. I find if you
Electronics Forum | Thu Sep 20 09:12:28 EDT 2001 | jschake
If you were successful in running the machine in dry cycle mode, then I would expect with new squeegees that the prints would be acceptable. To give you more tangible data on what you may expect from the actual print results, maybe you could run the
Electronics Forum | Thu Oct 08 22:20:44 EDT 1998 | Dave F
| | | I am trying to find out, what possibilities I have, to print solder paste on a board, when the task is to have 120 Microns thickness for the biggest part of the board (85% of the real estate), and then have 250 Microns of thickness on the rema
Electronics Forum | Fri Oct 09 04:08:45 EDT 1998 | Thomas Blesinger
| | | | I am trying to find out, what possibilities I have, to print solder paste on a board, when the task is to have 120 Microns thickness for the biggest part of the board (85% of the real estate), and then have 250 Microns of thickness on the re
Electronics Forum | Tue Sep 29 09:39:02 EDT 2015 | rgduval
Hey, David, For service, check out 4TechUSA over in Detroit. It's not Chicago, but, you're closer to Detroit up there than I am down here in Houston :) For your issue....do you have access to the UIC Knowledge Base? The first issue I found in the
Electronics Forum | Wed Sep 15 20:30:57 EDT 1999 | Bach Huss
| | Hi, | | | | Recently encountered missing components problem at the SMT process. | | Among 13 chip components from the same part number mounted on the board, only 4 ( located in a same row and next to each other) were missing after post reflow. C
Electronics Forum | Mon Jun 17 03:09:37 EDT 2024 | roetestify
Calibrating the Panasonic NPM-W2 HMI display is crucial to ensure precise touch sensitivity and accuracy. Here's a step-by-step guide: Begin by accessing the setup or configuration menu on the Panasonic NPM-W2 HMI device. Look for an option specific
Electronics Forum | Mon Mar 29 16:19:28 EDT 2010 | rodrigo
Hi All, I just realized that our CP-6 is reading only two of three fiducials. Is this normal? The coordinates are not the same and they're numbered 1,2,3. We use the MCS30. I checked the proper data and I couldn't see anything that would cause it to
