Electronics Forum | Mon Jun 19 13:00:16 EDT 2006 | fabio
"Z tower obstruction - machine must reset". I�m having this problem in the machine... please help!!
Electronics Forum | Mon Jun 19 14:00:46 EDT 2006 | choppy
Check for anything that may contact while activating Z tower (support, wire, connector, etc) I also saw one day a lost PCB causing that kind of problem ?!?!?!?
Electronics Forum | Mon Jun 19 15:13:42 EDT 2006 | Chunks
There is also plastic link on the shaft that raises your Z-Table that may have come lose or broken. Is the Z-Table able to move up and down in Supervisor mode?
Electronics Forum | Mon Jun 19 21:25:47 EDT 2006 | Chris
Try raising the table in Calibrate mode. Sensor or Tactile connector could be contacting the underside of the rails and overloading the axis. Check for 24V on the Z-axis brake. Check the fuse(F5) and voltage to the driver. Check DIP switch settin
Electronics Forum | Fri Mar 18 14:08:02 EST 2005 | ceo
no
Electronics Forum | Thu Mar 17 15:03:23 EST 2005 | debh
Has anyone ever tried to use "Reel Scan" (brand) barcoding with Juki machines. We currently have 730-2020 and 2050-2060 lines set up. Was wondering how the compatibility is. (I think I already know the 730 is out...) I'll be asking the vendor also, b
Electronics Forum | Thu Jul 26 05:53:38 EDT 2001 | greggy
Hi, I would like to get some feedbacks about the Juki 2000 Series regarding performance, downtime, accuracy on fine pitch components and 0201's and 0402 chips, repeatability, and reliability. thanks and regards,
Electronics Forum | Tue Feb 28 11:38:04 EST 2006 | Chunks
What year? Also, check fuses.
Electronics Forum | Mon Feb 27 13:33:03 EST 2006 | Robert
Our MPM 2000 screen printer machine has a problem. During the machine reset mode a warning message come up "Z lockout not operating". Does anyone know what fault could cause this?
Electronics Forum | Mon Feb 27 21:08:21 EST 2006 | ChrisG
I have never seen that message before, but you should check the Z axis driver card, and the Z home sensor. Do you hear anything when the axis tries to move?
.gif)
