Electronics Forum | Fri Sep 18 03:02:07 EDT 2015 | linux
Hello everyone. Need urgent help with our cp6, when front door is open servo amp alarm comes up, this error will clear using the reset button. Has anyone any idea how I would go about fixing this issue.
Electronics Forum | Fri Jul 19 12:58:46 EDT 2013 | markhoch
The wonders of Google... Hope this helps. http://www.winsmt.com/down/001.pdf
Electronics Forum | Fri Jul 19 10:45:55 EDT 2013 | kdc45
Have a Fuji IP-2 and the MTU has a servo alarm. There are three servo amp cards and the middle card is showing a 1 on the LED display. Does anyone know what this indicates? Also, can you tell me which axis this card is for? We do not have an advanced
Electronics Forum | Fri Jul 19 13:50:29 EDT 2013 | kdc45
Thanks for the link, however, I have this manual already and it only shows how to replace motors, belts and prox switches and to adjust for zero set. Appreciate your time and efforts. I did find that it is an OC alarm. Thanks again. Regards, kdc45
Electronics Forum | Tue Oct 11 19:17:29 EDT 2005 | Dave
Hi Stephen! The nozzle change happens at a much slower speed to what it runs at during pick and place. They are a great machine...when everything works on them ;-) I tried sending through the proper data again and rebooted the machine. A interest
Electronics Forum | Mon Oct 10 15:24:15 EDT 2005 | zl3vlf
Hello to all! Our Fuji FIP-3 placement machine has come up with a servo alarm (X2-axis) whenever we try to run the machine. The manuals don't go into a lot of detail as to the cause of this problem, but there is plenty of information on what the X2
Electronics Forum | Tue Oct 11 08:54:18 EDT 2005 | jdengler
-Are you running a program that worked before or is it a new program? -Is there any reason to suspect that the proper has been edited between working and error condition? Jerry
Electronics Forum | Tue Oct 11 15:30:28 EDT 2005 | Dave
Hi Jerry, I thought the same so tried running other programs that are known to work on the IP-3 but still no joy. I shall try Alan's suggestion with cleaning the linear scale and see what happens. Thanks!
Electronics Forum | Mon Oct 10 22:56:13 EDT 2005 | Alan.
Dave, it could be that you have some dirt or grease on the linear scale for the X-axis. Try getting into the rubber shield with a soft brush or perhaps a spray. Threebond Super Cleaner 6602 is very good for this purpose as it cleans and dries w
Electronics Forum | Tue Oct 11 18:21:36 EDT 2005 | stepheniii
Does it do nozzle changes at a different speed than the programs? It's been a while since I worked on these beasts. I"m wondering if it can handle slow speeds but at full bore it can't handle it. Maybe try one part with everything set to slow speed
