Electronics Forum | Mon Jan 31 13:02:43 EST 2005 | jgarver1
Do you have an extra VME Servo Board to try? Servo Overflows are not as common as Over Currents or hard amplifier failures. They seem to be resolved by replacing the servo board and not the amp or motor. My $.02
Electronics Forum | Fri Jan 10 03:33:42 EST 2014 | hans88
hello people, we have a my12 wich has a problem it gives the following error during hardware initialization: F-MOT-MSETDYN Y/1236 :Motor amplifier channel a error. after this error it says hardware initialization failed. this prevents us of using
Electronics Forum | Fri Jan 10 15:33:57 EST 2014 | hans88
Hello Rob, Thanks for your fast reply. I will check the parts you mentioned. You were right about the mot card we swaped it with a new one but that made no difference. Today we tried to find were the problem could be we: - removed the j1, j2 and
Electronics Forum | Wed Jun 25 18:19:49 EDT 2014 | guts1872
During machine run, sometimes when we stop to change parts the servos wont start back up. There is a message on the screen that says "Amplifier is resetting power". When that message clears and push the servo on button nothing happens. There is an er
Electronics Forum | Fri Aug 30 15:44:51 EDT 2019 | valentink
I will try outline Theta and Z-axis servo issues, we were facing last time. Story behind. Our 750 is used seldom and last time after switching it on initialization procedure ends with T axis of right head: Servo alarm. Opening front cover of 750 two
Electronics Forum | Thu May 21 20:25:26 EDT 2009 | voytek
I had to replace two Y-axis servo amplifiers on our GSM1 machine. I'm sitting on two faulty servos that I would like to have repaired. Let me know if you now place which specializes in repair of Servo Amplifiers Mod. No. 800-444 by Copley Controls.
Electronics Forum | Wed Nov 03 12:57:28 EDT 2010 | adrianam
I need some help with the following alarm appeared on Fuji FCP4-3 : ,,Servo Amplifier alarm on X, Y, C, Z axis". When I push the reset button, remain ,,Servo Amplifier Alarm on D, F theta axis". All the sensors and solenoid it were checked and is OK
Electronics Forum | Fri May 22 17:03:26 EDT 2009 | voytek
Thank you Steve.
Electronics Forum | Wed Nov 03 14:44:45 EDT 2010 | aj
have you checked your power supplies are all giving correct outputs?
Electronics Forum | Thu Nov 04 02:14:19 EDT 2010 | adriana
Yes, we are checked all power supplies and is OK! Many thanks!
