Electronics Forum | Thu Feb 04 09:18:18 EST 2010 | mika
Problem! Then replace the motor! Why not replace be belt anyhow? How long was it since the last time you replaced any belt? Another thing you could also do; In the LP (Low Power) chassis lower front left, find the correct motor servo card and "Null
Electronics Forum | Wed Jul 01 13:41:25 EDT 2009 | jlawson
Are you sure it is the Z axis, and not the > rotation, I had one machine which often did > something similar, it would buzz loudly, > especially if you touched or applied rotation > pressure to the gear belt which rotates the > head. It never ca
Electronics Forum | Fri Jul 07 17:17:43 EDT 2023 | ttheis
We swapped the Y1 and Y2 pc800 controllers with no change. We swapped out the UIMC III-I cards from another machine with no change. VRM amps all look OK, no errors. The machine moves the head both in the x and y directions during the zeroing attemp
Electronics Forum | Tue Jul 11 23:28:59 EDT 2006 | donb
Hi All, I have a continuing problem here with mis-alignment of parts on one of our Fuji CP-3 machines and I thought one of you esteemed engineering types may be able to give me a clue as to where the problem might lie. I have a Fuji trained enginee
Electronics Forum | Thu May 12 04:37:30 EDT 2005 | Rob
1) Only if it's a real enhancement, and not to fix a fault in your design. 2) No, it just has to be instinctive & accurate. 3) Barcode is fine by me, but others swear by data matrix 4) Better than 1 in 10,000 - which could be once every 5 boards.
| 1 |
.png)
