Electronics Forum | Wed Jul 21 14:57:57 EDT 2004 | Steve
I have some servo driver boards that intermittantly fail and would like some information on getting them repaired. Do any of the members know of a 3rd party repair facility that can repair/exchange these boards? As not having a schematic for these so
Electronics Forum | Tue Jan 24 16:35:16 EST 2017 | siltron
Hi everyone, We bought a used Juki KE a few months ago. Installed it at the beginning of this year, but have some problems with the Z and ROT servos. As soon as the machine is powered on, the ALM04 red led turns on on some of the Z and ROT drivers.
Electronics Forum | Fri Mar 08 05:44:40 EST 2019 | bukas
are you sure #1 and #6 are interchangeable? if I remember correctly there is a catch with those motors, like there are 2 groups, group 1 being #1 #3 #5 and group 2 being #2 #4 and #6. maybe try getting it back and swapping cables at drivers for head
Electronics Forum | Fri Aug 30 15:44:51 EDT 2019 | valentink
I will try outline Theta and Z-axis servo issues, we were facing last time. Story behind. Our 750 is used seldom and last time after switching it on initialization procedure ends with T axis of right head: Servo alarm. Opening front cover of 750 two
Electronics Forum | Sun Mar 31 07:43:32 EDT 2013 | lkavan
Thank you very much, you are an angel, DOS software works with these drivers! But some servos still shaking and I cannot tune it by decreasing the gain or autotuning :-( Problem is with driver, when I change it servo works well. All drivers have the
Electronics Forum | Tue Oct 14 07:38:29 EDT 2014 | dilogic
Z axis drivers are located in co-salled LP servo bay. It is 19" rack mounted in lower left part of the machine. Head1 z axis driver is in slot 4 and head2 driver is in slot 6
Electronics Forum | Thu Nov 03 13:28:48 EDT 2016 | jimmyboz
If there are no errors, check main relay contacts, it is common that one contact is not closing.
Electronics Forum | Wed Mar 23 23:00:17 EST 2005 | pmd
Problem solved. Thru the help of MyData support we have determined that older MyDatas have a software issue with the servo drivers. A newer rev of driver will fix this problem.
Electronics Forum | Sat Jan 21 10:28:16 EST 2023 | compit
The so-called "drivers" are used to control each servo - control boards at the back of the machine. There are several (8?). If one is "worn out" and has no strength to move the servo, maybe this is where the error comes from? They can be interchanged
Electronics Forum | Wed Nov 02 16:35:20 EDT 2016 | csm
Dear FUJI Specialist, I need your HELP, we have an CP8-42-E and machine was working properly and from one day to another when we Turn ON the machine make all the startup and check all the list, when all is ready, you have to Puch Ready and automaticl
