Electronics Forum | Wed Jul 21 14:57:57 EDT 2004 | Steve
I have some servo driver boards that intermittantly fail and would like some information on getting them repaired. Do any of the members know of a 3rd party repair facility that can repair/exchange these boards? As not having a schematic for these so
Electronics Forum | Fri Dec 19 17:11:24 EST 2014 | guts1872
My QSP2 motors keep shutting off with an error message on the screen that says Z1 motion fail. Z safe motion motion failed due to previous error. When homing the heads I observe the servo amp indicator LEDs. They are all green while the gantries are
Electronics Forum | Fri Jan 15 14:32:12 EST 2021 | marcelorotofrance
Hey there We have a second hand (or third or fourth...) Contact 3Z-100 non functioning, received as is. I am in the process to asses its condition and try to get a diagnosis. After DOS boot, 3Z.EXE executes and in the screen it reads: "Initi
Electronics Forum | Tue Jan 24 16:35:16 EST 2017 | siltron
Hi everyone, We bought a used Juki KE a few months ago. Installed it at the beginning of this year, but have some problems with the Z and ROT servos. As soon as the machine is powered on, the ALM04 red led turns on on some of the Z and ROT drivers.
Electronics Forum | Fri Mar 08 05:44:40 EST 2019 | bukas
are you sure #1 and #6 are interchangeable? if I remember correctly there is a catch with those motors, like there are 2 groups, group 1 being #1 #3 #5 and group 2 being #2 #4 and #6. maybe try getting it back and swapping cables at drivers for head
Electronics Forum | Fri Aug 30 15:44:51 EDT 2019 | valentink
I will try outline Theta and Z-axis servo issues, we were facing last time. Story behind. Our 750 is used seldom and last time after switching it on initialization procedure ends with T axis of right head: Servo alarm. Opening front cover of 750 two
Electronics Forum | Sun Mar 31 07:43:32 EDT 2013 | lkavan
Thank you very much, you are an angel, DOS software works with these drivers! But some servos still shaking and I cannot tune it by decreasing the gain or autotuning :-( Problem is with driver, when I change it servo works well. All drivers have the
Electronics Forum | Wed Nov 02 21:34:38 EDT 2016 | ttheis
Check fuses, breakers and power supplies on the machine for proper operation. Start with the basics.
Electronics Forum | Tue Apr 04 23:01:37 EDT 2000 | Dean
Does Fuji America have a trade in program? I know they used to on vision cards and such. It may be worth your while to get a trade in allowance rather than none at all. The alternative, as you mentioned, is to repair it yourself. This however, w
Electronics Forum | Tue Sep 21 18:46:24 EDT 2010 | slwolbert
Greetings: > > I am having 'Check Servo' issues > with an FCP 2 4000. It will zero set but given a > few minutes afterwards, the check servo alarm > sounds. > > At times the X/Y table will 'coast' > back to beginning position, like the power
winsouce.jpg)
