Electronics Forum | Fri May 01 00:27:12 EDT 2009 | rodrigo
Hi all, We had a servo amp replaced (SA-6) and the machine worked with no problem for the first panel (this panel of 10 only needs a TQFP100 from the MTU). Then I got the "Servo NG" error again. One of the servo paks showed a "7" on the LED. The err
Electronics Forum | Fri Apr 24 22:59:08 EDT 2009 | smellew
Good news Rodrigo, Llew
Electronics Forum | Tue Mar 10 14:21:45 EDT 2009 | smellew
yes this would be normal as that is when the servo power is supplied for servo lock, do you have a new servo amp?
Electronics Forum | Mon Mar 09 15:40:32 EDT 2009 | smellew
Rodrigo, Is your machine IP2 or IP2E? if you still have the problem contact me direct, and i will take you through the Schematics. Llew Llew@SurfaceMountEngineering.com
Electronics Forum | Mon Mar 09 17:05:05 EDT 2009 | rodrigo
It is an FIP-II 4000. I rather do it through here so other people can benefit. Thanks
Electronics Forum | Fri Apr 24 16:57:23 EDT 2009 | rodrigo
We replaced SA-6 with a new one and the IP2 is up and running. I don't know if you're still looking at this thread but I wanted to thank you and post the result so other people benefit. Thanks so much for the help. Rodrigo
Electronics Forum | Mon Mar 09 13:07:52 EDT 2009 | rodrigo
Hi all, Our IP-2 stop working during production with a Servo NG error. Turning it on and off just goes back to the same thing or "Turn servo power on" error message. I was checking the power for the servo amps and I found a 35VAC line that is missin
Electronics Forum | Wed Mar 11 12:23:08 EDT 2009 | rodrigo
I changed the satus B bit to disable the MTU (still on though). It doesn't wait for the MTU anymore but I get a Emergency and Door NG errors. The relay tripped. Is there a way to completely disable the MTU (leave it off) and power up the IP? This sho
Electronics Forum | Wed Mar 11 13:18:32 EDT 2009 | smellew
Even if you disable the MTU(see address 1005 to link out E-stop & address 1219 for the safety fence rear) the servo still needs to be replaced. SA6 is the faulty one, i'm sure there are many dealers who could supply you one. if you need further conf
Electronics Forum | Fri Mar 13 16:23:10 EDT 2009 | rodrigo
We're going to swap SA-4 and 6 but it is going to take a few days. Thanks for all the help. Follow up: We swapped SA-7 and SA6 (because SA-4 was different). The problem stayed with the original amp. so we're looking for a replacement. Our buyer is h
.gif)
