Electronics Forum | Fri Dec 19 17:11:24 EST 2014 | guts1872
My QSP2 motors keep shutting off with an error message on the screen that says Z1 motion fail. Z safe motion motion failed due to previous error. When homing the heads I observe the servo amp indicator LEDs. They are all green while the gantries are
Electronics Forum | Thu Mar 21 12:09:28 EDT 2019 | alexcouto
Hello Bukas, thanks again. Since at an early stage I switched heads # 1 and # 6 and they are not compatible, then I went through the manual and figured out why. in order to start at the beginning and check that it had not damaged anything, I put the
Electronics Forum | Fri Aug 30 15:44:51 EDT 2019 | valentink
I will try outline Theta and Z-axis servo issues, we were facing last time. Story behind. Our 750 is used seldom and last time after switching it on initialization procedure ends with T axis of right head: Servo alarm. Opening front cover of 750 two
Electronics Forum | Mon Mar 09 13:07:52 EDT 2009 | rodrigo
Hi all, Our IP-2 stop working during production with a Servo NG error. Turning it on and off just goes back to the same thing or "Turn servo power on" error message. I was checking the power for the servo amps and I found a 35VAC line that is missin
Electronics Forum | Tue Apr 17 13:07:17 EDT 2012 | rodrigo
Well... after much headache I found a bad relay contact in M1CR1E. The good news is somehow the axis are no longer jerking. The bad news is that it still does not work. When I turn it on now it shows this: emergency stop (in red) waiting for reset
Electronics Forum | Thu Jan 08 12:43:31 EST 2009 | davef
Here's few more ideas: * Have vending machine vendor turn off advertising lights * Turn-off photocopier at night * Switch off all unnecessary lights * Use dimmers, motion sensors, or occupancy sensors to automatically turn off lighting when not in us
Electronics Forum | Tue Oct 11 19:17:29 EDT 2005 | Dave
Hi Stephen! The nozzle change happens at a much slower speed to what it runs at during pick and place. They are a great machine...when everything works on them ;-) I tried sending through the proper data again and rebooted the machine. A interest
Electronics Forum | Wed Jan 16 22:32:41 EST 2002 | alex_k
I am looking to make a circut that uses a pulse from a dome switch to turn on two LED's, then turn them off with another pulse. What is the smallest way to do this? Is an ASIC a possiblity? Thank you
Electronics Forum | Mon Jun 13 19:07:57 EDT 2005 | bobpan
Mike, Right down all the settings you have for your machine (this may take a while). Also back up the programs you want to save. Now....if i can remember correctly.....when looking into the black computer box from the back of the machine...in your bo
Electronics Forum | Wed Aug 28 10:51:27 EDT 2002 | edmentzer
We use a manual "pick and place" unit similar to the OK product, and it work great. The parts are in a tray and the operator moves the pick up head over the part and press down which turns on the vacuum, the vacuum is turned off when the part is pla
